How do I reset my KitchenAid dishwasher control panel?

To reset the dishwasher control panel, it needs to be disconnected from the power source for one minute. If your dishwasher is plugged into an outlet, simply unplug the unit for one minute and then plug the unit back in.

How much does it cost to replace a KitchenAid dishwasher control panel?

$150 to $350
Dishwasher Control Panel Repair Cost Dishwasher control panel repairs average $150 to $350, depending on the problem. The control panel interacts with your dishwasher, programming things like time and temperature, so it can make the appliance inoperable if it has a fault or failure.

How do I test my dishwasher control board?

To determine if the control or keypad is faulty, do the following test:

  1. Unplug dishwasher or disconnect power.
  2. Open the dishwasher door.
  3. Open console and disconnect the keypad ribbon connection from the control (at P1).
  4. Put console back together.
  5. Plug in dishwasher or reconnect power.
  6. Wait 5 seconds.

Is there a way to reset a KitchenAid dishwasher?

To reset your Kitchenaid dishwasher:

  1. Press both “Energy Saver Dry” and “Hi-temp Scrub” buttons 5 times simultaneously.
  2. After doing so, you should see the lights on the control panel display flash repeatedly for 4-5 seconds.
  3. Afterward, let the unit sit for 10 minutes to give the dishwasher time to reset.

Where is the reset button on KitchenAid dishwasher?

KitchenAid Dishwasher Control Panel Reset

  1. When powering down the dishwasher and turning it back on is not working, It may be best to reset the control panel.
  2. You can reset it by pressing two buttons on the front of the dishwasher at least five times each for a grand total of ten presses.

Is there a reset button on a KitchenAid dishwasher?

If you just need to reset a cycle, simply press and hold the Cancel or Cancel-Drain button to reset the cycle and choose a new one.

How do I turn the Control Lock off on my KitchenAid dishwasher?

To turn off Control Lock, press and hold the Options key that says “Control Lock Hold 3 Sec” under it for 3 seconds. If the dishwasher has a dedicated Control Lock button in the Options selections, press and hold CONTROL LOCK for 3 seconds.