How much HP can you get out of a 6.0 LS?
How much HP can you get out of a 6.0 LS?
If we were to run the 6.0L in stock trim, the resulting power output would be around 400 hp (on this dyno the way we test). If we apply 14.5 psi from our turbos to the stock 400hp engine, we might get 800 hp.
How much power can you get out of a LS2?
The LS2 engine block has a 4.000-inch bore diameter. The cylinders can be bored to 4.030 inches. However, we recommend leaving them as thick as possible when running boost. The block can handle 850 horsepower.
How much hp does a cammed 6.0 make?
See all 18 photos After installation of the TrackMax cam, the power output of the 6.0L LY6 jumped from 443 hp and 467 lb-ft of torque to 514 hp at 5,900 rpm and 493 lb-ft of torque at 4,600 rpm.
How much HP does a 408 LS Stroker have?
449 hp
Equipped with the stock 5.3L truck cam, the 408 stroker produced 449 hp at 5,100 rpm and 522 lb-ft of torque at 3,900 rpm.
What is a 408 stroker LS?
The 408 stroker test mule started out life as a lowly LQ4 6.0L truck motor. The iron truck block was machined to accept a forged rotating assembly that included a 4.0 inch (up from the stock 3.622 inch) Scat forged steel crank, matching 6.125 inch I-beam rods and JE forged pistons.
How much HP can a stock block LS2 handle?
Registered. The LS2 block-can it handle 25-28 psi, max power limited to 1100 rwhp ( YSi ).
How much HP can a stock LS2 crank handle?
Registered. the stock crank can easily handle 800+ hp. There are some using them up to 1000 hp.
How much hp can a 6.2 handle?
4, 6.2L truck engines are closely related to the LS3 used in Corvettes and Camaros. Basically stock engines can make 650 hp. under boost. With upgraded internals, they can handle over 1,000 hp.
Is a 6.2 A big-block?
The 6.2L engine could be described as a 6.2L big-block modular. Most big-block engines have more than 400 cubic inches of displacement and they weigh more. And the small-block engines have a smaller displacement. The 6.2L engine, though, fits into a 4.02-inch bore.