How do I get my Dodge out of theft mode?

To deactivate the anti-theft system so that you can drive your vehicle normally once again, the steps are simple:

  1. Place your key in the ignition of the vehicle.
  2. Do not attempt to crank up your truck.
  3. Allow your key to sit in the ignition for 60 seconds.
  4. After 60 seconds have passed, start your vehicle as normal.

How do I reset my security anti-theft system?

Put the key in the ignition and rotate forward two clicks to the “On” position that makes the dashboard light up, but don’t try starting the car. Leave the key there for 15 minutes; it doesn’t always take that long, but it can. After that time, check to see if the anti-theft light has gone out, if one was lit up.

How do I get my car out of anti-theft mode without remote or key?

Ways to stop a car alarm without a keyfob

  1. Check your owner’s manual. Every vehicle is different.
  2. Lock your doors.
  3. Turn the car on.
  4. Turn the ignition to on and wait.
  5. Pull the fuse for the alarm.
  6. Pull the wires for your alarm.
  7. Disconnect the battery.

How do you reset an immobilizer?

Hold the panic button for five seconds to reset the immobilizer. Then press the lock button twice and wait ten meters from the car for ten minutes.

How do you fix anti-theft lock?

There are some cars that will recognize the key by just turning back and forth on the key inside of the door’s lock key cylinder. Try to turn the car key fully both ways to disable its anti-theft system. Step 3: Try starting the engine. Take the key out and then try starting the engine.

How do I get my car out of security mode?

Look for a button that allows you to slide the physical key out of the fob. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in this position. This will signal to your car’s system that you have the right key, and will enable you to bypass your car’s alarm system.