Why is my tire pressure light blinking Subaru?

The TPMS signifies that one or more of your tires is not at the correct tire pressure. It’s time to pull out your tire gauge and pump, or find yourself a gas station.

Why is my tire pressure light blinking?

What Does It Mean When the TPMS Light is Flashing? The tire pressure sensors use a battery, and if the TPMS light is flashing, it could mean that the battery needs to be replaced. It could also indicate a problem with one of the sensors.

Can I drive with a blinking tire pressure light?

If the pressure is low, inflate the tire to the optimal level. Drive for some time and check if the warning light is still flashing. If not, you’re good to go. If the light still flashes, take your car to the nearest mechanic and check your tires.

How do you clear the low tire pressure light on a Subaru?

Press the TPMS reset button and hold it until the light blinks three times, then release it. Start the car and let it run for 20 minutes so it can reset the sensor. The tire pressure monitor reset button is located beneath the steering wheel.

What does it mean when the TPMS indicator light blinks for 60 seconds?

A TPMS warning light that illuminates solid and remains solid usually means that one or more of the tires has low air pressure and needs to be inflated to the correct placard pressure. However, a light that flashes for 60-90 seconds and then illuminates solid is signaling that there is a problem with the TPMS system.

Where is the TPMS reset button Subaru?

The Subaru Forester tire pressure monitoring system is located on the lower right-hand corner of the instrument panel. The reset button is a small, red circular button located just below the TPMS icon.

Why does my car say tire pressure low when it’s not?

In most cases, the warning light may be triggered by a tire that is 10% to 15% low in air pressure. Cold or icy weather also has a tendency to lower the air pressure inside the tires. Taking the car for a short drive will heat up the tires and increase the tire pressure.

How to reset a tire pressure light?

Drive at or above 50 mph for 10 minutes – your sensor should hopefully reset the next time you turn on the car.

  • Starting with the vehicle off,turn your key to the “On” position,but don’t start the vehicle.
  • Inflate each of your vehicle’s tires to exactly 3 PSI over their recommended amount,and then completely deflate them.

    • Is it safe to drive with tire pressure light on?

    This has always been a big question, is it safe to drive with a TPMS light on. The answer is yes, it is safe, BUT always make sure that your tires are aired to the correct pressure. Also, be sure there isn’t something causing your tire to leak. It is always good safety practice to inspect your tires before driving.

    What are the best tires for Subaru Legacy?

    – Cooper CS5 Ultra Touring – Goodyear Assurance ComforTred Touring – Michelin Premier A/S

    Why does my low tire pressure light stay on?

    Outside Temperature Change (Most Likely) If you live in a cold climate,keep tire temperature measurements outside the house in the morning.

  • Tire Change or Rotation was Recently Performed.
  • The TPMS Sensors are damaged.
  • The wheel speed sensors are faulty.
  • Pressure in Spare Tire is Low.