How do I clean my Epson DS 40?

How should I clean the inside of the product?

  1. Turn on the scanner and make sure it is connected to the computer.
  2. Load the dry cleaning sheet into the scanner.
  3. Do one of the following to start Epson Scan Settings:
  4. Click Maintenance.
  5. Click Cleaning.
  6. If the scanner is not clean, repeat these steps to clean it again.

How do I scan double sided on my Epson DS 410?

To scan a double-sided document in the ADF, press the Scan button, select your scanning method, then press the Menu button. Select Scan Settings > 2-Sided Scanning. If you are using the EPSON Scan software, select ADF – Double-sided as the Document Source (Office or Professional Modes only).

How do I connect my Epson scanner to my computer?

Epson Scan: Network setup

  1. Open Epson Scan Settings.
  2. Select your all in one printer or scanner from the drop down list. Note:
  3. Set Connection Type to Network.
  4. Click Add.
  5. Click the IP address in the list and click OK. Note:
  6. Click Test. Successful Test.
  7. Expand the section below depending on the test results.

How do I connect my Epson 60W scanner to my computer?

How do I connect my product with a Wi-Fi Direct connection?

  1. Set the Wi-Fi switch on the scanner to the Wi-Fi position.
  2. Turn on the scanner.
  3. From your computer or device, search for and select the SSID shown on the label on the bottom of the scanner.
  4. Enter the password shown on the label on the bottom of the scanner.

How do I clean my Epson scanner rollers?

Wipe the rollers with a lint-free cloth dampened with water and thoroughly wrung out. Wipe off all remaining liquid with a soft, dry, lint-free cloth. Make sure that the rollers are completely dry before using the scanner.

Why is my scanner showing colored lines?

Color stripes or lines result on the scan output when scanning from the Automatic Document Feeder (ADF). This is typically caused by dust, paper particles, or scratches on the scanner glass.

Why does my Epson scan only scan one page?

Cause: The Scanner Source is setting to Flatbed and needs to be changed to ADF (Automatic Document Feeder).