Who makes dr44 alternator?

Who makes dr44 alternator?

Genuine AC Delco – LS 160 Amp Alternator

How many amps is a dr44 alternator?

This Delco Remy 12V DR44G alternator is for Freightliner MT-45 trucks and Workhorse P4500, W42,W62, and 2-Ton. This Delco Remy alternator contains 12 volts, 145 amps.

How many volts should a Chevy alternator put out?

13.5-14.5 volts
A good alternator should put out between **13.5-14.5 volts. Stress test the alternator – Place a load on the alternator by turning on the headlights, the radio and the air conditioning.

Is 14.8 volts too high for alternator?

14.8 would start to be a worry (there might be liquid or corrosion on the battery) and 15 volts would be a real concern, but 14.6 is fine. Less than 14.3 would be a “weak” alternator or regulator. Much less than 14.2 at a fast idle is bad wiring, bad alternator or regulator, or a bad connection or fuse link.

Why is my alternator not putting out enough voltage?

Poor ground connections are an often-overlooked cause of low charging output and alternator failure. Check for voltage drops at the positive and negative battery cable connections, the alternator BAT+ power connection and the engine ground strap(s). Voltage drops on the negative side can cause overcharging.

Can you adjust a regulator on a an alternator?

Some alternators with an old configuration allow adjusting of the voltage regulator. On these units, you can find a small adjusting screw on the voltage regulator.

Is 13.8 volts good for alternator?

At that point, if the voltage falls between 12.6 and 13.7 volts, you need to replace your alternator. If it’s greater than or equal to 13.8 volts, a voltage drop test needs to be performed.

Is 14.9 volts too high for an alternator?

14.5-14.6 is normal voltage while the alternator is running.