How do you wire a 24V trolling motor plug?
How do you wire a 24V trolling motor plug?
Feed the wires through the plug housing. On the 12-24V trolling motor plug, connect the positive 24V wire to the terminal marked “24”, the 12V wire to the terminal marked “12” and the negative wire to the terminal marked “-”. On straight 24V trolling motors, connect the two wires to “24” and “-” as appropriate.
Are trolling motor plugs universal?
Unfortunately, most trolling motor plugs and receptacles are not compatible with each other as there isn’t a universal plug design.
Why does my trolling motor receptacle have 4 wires?
Attach one set of red and black wires to one battery’s positive and negative poles and the other set to the other battery or battery setup. Trolling motors with four wires usually have switches that allow you to choose which battery setup to use.
What size wire is needed for a 24v trolling motor?
Wire Gauge And Circuit Breaker Size Guide
| Cell | Amps drawn | 15 ft length |
|---|---|---|
| 12 volt | 30 | 8 awg |
| 12 volt | 42 | 6 awg |
| 12 volt | 50 | 4 awg |
| 24 volt | 42 | 8 awg |
Do trolling motors need a circuit breaker?
It is highly recommended that a circuit breaker or fuse be used when installing a trolling motor.
How do I test a trolling motor plug?
Measure, with a voltmeter – the voltage that is going into the two ends of the wires going to the front of the boat for the trolling motor. You should have 36 volts. Then, go to the trolling motor connector, and measure again. Just put one probe in one connector hole and the other probe in the opposite hole.
Why does my motor have 4 wires?
There are several electric motor types that use brushes for d.c. operation. These have two wires. Reversing th polarity of the applied voltage reverses the rotation. These have 4 wires.
How do I know if my trolling motor is 12 or 24 volt?
The nameplates are most often found in the foot petals of the motor. Otherwise, you can look at the configuration of the trolling motor batteries to find the volts. Open the hood and look at the battery. If you see 6 cells, it’s a 12-volt battery, but if you see 12 cells, it means it’s a 24-volt battery.
What happens when you run a 24 volt trolling motor on 12 volts?
24v hooked to 12v will spin for a while on a full battery but there will be no torque. You could stop it with your hand. It is like running your motor with half the spark plugs missing.
How do you charge a 24v trolling motor battery?
You can’t charge a 24 volt system with just 1 regular battery charger. If all you have is the 1 charger you would have to disconnect the jumper wire between the 2 batteries and charge them seperatly, 1 at a time. The best way is to buy a dual(2 bank) marine boat charge and mount it in your boat.
