How do I Reset my Cisco wireless router password?

Cisco 3848V change password

  1. Visit the Admin Console by visiting 192.168.
  2. Log in with the following information:
  3. Click Login.
  4. Click Wireless at the top of the page.
  5. Click the Wireless Security tab.
  6. Under 2.4GHz Wireless Security, type a new password for the network in the Pre-Shared Key field.

How do I Reset my Rommon password?

Type reset at the rommon 2> prompt. Type no after each setup question or press Ctrl+C to bypass all questions. Type configure memory or copy startup-config running-config in order to copy NVRAM into memory. Type enable secret in order to change the enable secret password.

What is the Cisco default password?

cisco
The default username is cisco. The default password is cisco. Usernames and passwords are case sensitive.

How do I access my Cisco wireless router?

Cisco router login:

  1. Make sure you’re connected to your network.
  2. Open a browser, and go to 192.168. 15.1.
  3. Enter the username and password.
  4. Default login credentials.
  5. Next Up: Speed up your Wi-Fi connection.

How do I reset my password on my Cisco 881 router?

  1. Connect your Console Cable to the Router Console Port.
  2. Power on the Router. Check your Port. At search type run.
  3. open Tera Term. Select Serial & your Port. Press Ok.
  4. (1) Power off the Router. (2) locate the Reset Button -> Press and hold it.
  5. (1)Login using Cisco 881 Router Default Username & Password. username : cisco.

How to recover lost password from Cisco router?

Cisco Router Password Recovery-How to recover cisco router lost password. Use the normal terminal settings (9600 baud, no parity, 8 data bits, 1 stop bit, no flow control). After that, you should get the command prompt. Step2: Now you have to power OFF the router from the power switch. Get ready on your keyboard and turn the power switch to ON.

How do I recover a forgotten password?

Note The key to recovering a lost password is to set the configuration register bit 6 (0x0040) so that the startup configuration (usually in NVRAM) is ignored. This allows you to log in without using a password and to display the startup configuration passwords.

What happens if you power cycle a Cisco router?

Caution If you are going to power cycle a Cisco 4000 Series Integrated Services Routers router, we recommend that you first perform a graceful reload on the router. Power cycling the router without first performing a graceful reload might cause a loss of data stored in the NVRAM.