How do I connect to Linksys PAP2?

Setup Instructions Connect your Linksys PAP2 adapter to an existing router in your network. Plug one end of the Ethernet cable that came with your Linksys PAP2 adapter into an open port on your router. Plug the other end of the Ethernet cable into the ETHERNET port on the back of the Linksys PAP2 adapter.

How do I find the IP address of my Linksys PAP2?

Connect network cable, power supply and analogue handset. After the unit has finished powering up, pick up the handset and dial **** to access the Linksys voice menu. At the voice prompt, dial 110# and you should hear the IP Address of the unit.

How do I reset my Linksys PAP2 NA phone Adapter?

Factory Reset Linksys PAP ATA

  1. Connect an analog phone to any of the phone ports on the ATA.
  2. Dial * four times.
  3. Dial a special sequence 73738#. The ATA responds with “Press 1 to confirm or Press * to exit.”.
  4. To confirm the factory reset dial 1.

How do I update my Linksys PAP2 firmware?

Linksys PAP2

  1. Extract the “linksys-pap2-v3-1-22-ls. zip” file to your desktop.
  2. Click “Upgrade Firmware” It will throw out a warning message as shown below:
  3. Click “Continue”
  4. Enter the IP address of your PAP2 adaptor.
  5. Click “OK”
  6. Click “Upgrade” to start the firmware upgrade.
  7. Click “OK” to finalise the upgrade process.

How do I reset my Linksys PAP2 NA Phone Adapter?

How do I reset my Linksys VoIP phone adapter?

Using the Reset Button

  1. Leave your Linksys VoIP router powered on and turn the device around so the back of the unit is facing you.
  2. Press the red “Reset” button and hold it for 30 seconds, then release the button.
  3. Turn the router around so the front of the unit is facing you.

How do I reset my Linksys adapter?

Resetting Powerline Fast Ethernet Adapters

  1. Use a pin or any pointed object to press and hold the Reset button for 10 seconds.
  2. Check the LEDs of your Powerline adapter.
  3. Click the Linksys Powerline AV Utility icon.
  4. Click the Administrator tab.
  5. Click Restore.

How do I reset my Linksys pap2?

Dial * four times. Dial a special sequence 73738#. The ATA responds with “Press 1 to confirm or Press * to exit.”. To confirm the factory reset dial 1.

What is Linksys default password?

admin
The default password for Linksys routers is admin. For optimum security, it is recommended to change this password during setup.

How do I unlock my Linksys spa2102?

Here’s how:

  1. with the phone, enter * * * *
  2. enter 723646# to access web menu unlock.
  3. enter 79309925# as password (probably you could enter anything tbh)
  4. press 1#
  5. press 1#
  6. hang up.