Why is my creepy crawly not working?

If Kreepy Krauly is not moving or not pulsating. Check that the main drain and all suction lines are closed, except for the suction line to which Kreepy Krauly is attached (usually a skimmer). Check for debris in the filter or [pump basket]. Check for debris in Kreepy Krauly flapper.

Why is pool cleaner not moving?

If you have a suction pool cleaner that is not moving, check the cleaner hose. It should be firmly attached to the suction line in the skimmer or the cleaner line. If you check these and they are all connected, the next thing to do would be to make sure there are no air leaks in the hose.

Why does my creepy crawly keep getting stuck?

If your Kreepy Krauly is often stuck at one side of your pool there are two potential fixes. If the hose is too short then buy another line and have it extended out enough to cover the pool. On the other hand, if it is constantly being coiled then relaxing it or changing how you keep it stored will fix that problem.

Why does my pool vacuum keep stopping?

When a suction cleaner is sluggish or slow, it’s usually a clogged pump basket or dirty filter that is to blame. Other problems include holes in the cleaner hose, sucking air into the hose, or the filter pump could be drawing in air, reducing water-flow volume.

Why is there no suction on my pool vacuum?

Verify that the vacuum hose is firmly inserted into the inlet port at the skimmer; then inspect the hose for cracks or holes. The skimmer filter is dirty. Pull out the filter basket and check for debris that may be interfering with water flow to the pool pump. Air is getting into the pump through the pump cover.

Why does my pool pump not have suction?

It could be something blocking it, a dirty pool filter, or too much air in the system. If there’s something blocking your pump’s suction, check your filter gauge. If it’s 10psi above the normal reading, clean your filter. This will reduce pressure and reset your pump’s flow.

Why does my pool vacuum have no suction?

Where do weights go on Kreepy Krauly hose?

The hose weight should be installed on the first hose that connects to the Kreepy Krauly Head, about one third of the way up the hose.

Why is my pool vacuum sticking to the bottom?

JohnT. Your brushes may be worn out. They tend to stick badly when they are. Otherwise, you’ll need to reduce the flow through the vac by opening the drain or using a skimmer diverter.