Which model Hampton Bay ceiling fan do I have?

On Hampton Bay ceiling fans, the product number is usually found on a sticker (usually silver) on top of the motor housing. If you don’t have your packaging or manual, it may be difficult to see the label on your motor housing. Try using a mirror or your smartphone to take a picture of the label.

Where is the DIP switch on Hampton Bay fan?

You’ll find dip switches on your ceiling fan in two places. First, inside of the remote. To find it, you may need to open the remote and look inside the battery compartment. The matching and communicating dip switch will be found inside of the ceiling fan.

How do I reset my Hampton Bay ceiling fan?

First, turn off the power then switch it back on again and within 30 seconds of turning it on you will need to hold down the fan off button for 10 seconds. Doing this will reset it. However, if that didn’t work then you may need to sync the sensor in the fan with the remote control.

Why is my ceiling fan not spinning?

Frozen bearings REASON: Another common reason for a ceiling fan that won’t spin is frozen bearings. The bearings present inside the motor may have got stuck or frozen which may thus not be allowing the blades to spin. Even if you push the blades by hand, they won’t move if this is the cause or case.

Why did my Hampton Bay ceiling fan stop working?

If your Hampton Bay ceiling fan light is not working: Try checking the bulbs to make sure they are screwed in correctly. Replace any non-working bulbs. Reset your remote control.

How do I find my ceiling fan model number?

You will find the model number for all fans on the:

  1. Part guide or installation manual that came inside your ceiling fan box.
  2. Outside of the box.
  3. On the fan itself. Location depends on the type of fan: For Downrod-mount fans- ID sticker located on top of the motor housing (facing the ceiling of an installed fan).

Where are the DIP switches on a ceiling fan?

Setting DIP switches The DIP switches for the receiver are located on the flat surface of the receiver. The DIP switches for the transmitter are in the battery compartment.

How do you reset a ceiling fan?

If you ever need to reset your ceiling fan, it’s a simple process that shouldn’t take more than a couple of minutes. Unplug the fan from the wall and wait for 15 seconds, then plug it back in and turn it on with its remote control. This should be enough to get the fan back up and running.