Where does the red wire go on a car stereo?
Where does the red wire go on a car stereo?
The red wire is for the 12 volt ignition, which can be attached to the stereo. The yellow wire is the 12 volt battery wire, which should also be attached to the stereo for power.
Why is there no sound coming out of my car speakers?
If your car radio turns on, but no sound comes out, common parts you should check include; blown fuses, Wiring shorts, Faulting input, or Damaged speakers/wires. It could also be a simple solution, such as the source or audio output device.
What is the dual media player pin?
“1234”
Pairing a New Device The device name is “Dual Media Player”. The Bluetooth passcode is “1234”.
How to install a stereo in a new car?
A DIN cage or mounting bracket may be necessary to secure the stereo to your dash. You should also purchase a wiring harness adapter so that you can plug your new stereo into your car’s electrical system. Gather all the necessary tools.
What is the output power of the dual car audio stereo?
Power Output: 18 Watts RMS x 4 channels at 4 ohms and < 1% THD+N Signal to Noise Ratio: 70dBA (reference: 1 watt into 4 ohms) Title Dual Car Audio Stereos Installation Instructions
How do you connect a stereo plug to a wire harness?
A few quick steps is all that it takes to connect the new stereo plug and wire harness adapter. Match the colors and sizes of wires on the plug to their identical counterparts on the wiring harness adapter. Strip approximately two inches insulation off of all of the wires and twist matching wires together.
How do you wire a car radio to a new car?
Connect the new radio’s plug to the wiring harness adapter. The new radio will have a plug that must be spliced to the wiring harness. The harness adapter and plug are made to go together easily. This adapter set up will allow you to plug the car’s original wiring harness into your stereo.
