What offset for 72 C10?
What offset for 72 C10?
Wheel Fitment Guide
| Vehicle | IFS Type | Front Backspacing |
|---|---|---|
| 67-72 C10 | WRIFS | 5-3/4″ |
| 5″ | ||
| 4-1/2″ | ||
| 67-72 C10 | IFS Stock Crossmember Ride Tech A-Arms Air Ride | 5-1/2″ |
How wide is a 1970 C10 rear end?
The 70 1/2 and earlier width is 62-3/8″ from wheel mount to wheel mount. The 70 1/2 and later (up to about 78 or so) width is 63-3/4″ from wheel mount to wheel mount. 1/2 ton was the same width as the 3/4 ton. A GM12 bolt is a tough setup.
How do I know if my 7.5/10 bolt is rear end?
Although the 7.5-inch 10-bolt closely resembles the 8.5-inch housing, you can positively identify the Chevy 7.5-inch rearend by measuring it. The oval-shaped cover measures 8 5/16 inches by 10 9/16 inches. The distance between the bottom center bolt in the cover and its adjacent bolts is 3 1/4 inches.
How low can you drop a C10?
Just spindles can drop you two inches, but if you elect to get aftermarket springs as well it’s possible to go down as low as 5 inches.
What lug pattern is a 1986 Chevy C10?
Chevrolet C10 Bolt Patterns
| Year/Make/Model | Bolt Patterns |
|---|---|
| 1984 Chevrolet C10 | 5x127mm (5×5″) |
| 1985 Chevrolet C10 | 5x127mm (5×5″) |
| 1986 Chevrolet C10 | 5x127mm (5×5″) |
| 1987 Chevrolet C10 | 5x127mm (5×5″) |
What’s better 10 bolt or 12 bolt rear end?
First, the 10-bolt’s pinion shaft diameter is 1.438 (25 splines) while the 12-bolt is 1.625 (30 splines) which makes the 12-bolt 13 percent larger in diameter and therefore stronger.
What is the bolt pattern for a 1971 Chevy C10?
The 1971 Chevrolet C10 2wd bolt pattern is 5-127 mm. This means there are 5 lugs and the diameter of the circle that the lugs make up measures 127 mm or 5 inches across.
