What is WR702N?

TL-WR702N is the smallest wireless router in the world and very easy to use. A traveler need simply plug a hotel room’s WAN cable into the port provided and enter a default password to instantly create a wireless hotspot in the room. Flexible Power Supply—Easy to Take on the Road.

How do I set my TL WR702N as a repeater?

Connect the WR702N directly to your computer’s Ethernet port by an Ethernet cable;

  1. Power on the WR702N.
  2. Click OK to exit.
  3. Open a Web Browser -> Type 192.168.0.254 in the address bar -> Press Enter.
  4. Enter the default Password: admin.
  5. Go to Quick Setup-> Click Next.
  6. Select Repeater-> Click Next.
  7. Click Survey.

How do I reset my TL WR702N?

With the Router powered on, press and hold the WPS/RESET button (more than 10 seconds) until the SYS LED becomes quick-flash from slow-flash. Then release the button and wait the Router to reboot to its factory default settings.

Can I use TP-link router as WiFi extender?

But what happens if your home is too large for a single Wi-Fi router to cover? If that’s the case, you can always get another TP-Link Wi-Fi router and use it as a repeater. That means you will get to extend the coverage of your primary router, so it covers the entire house.

What is the default WIFI password for TP Link Router?

The default IP address is 192.168. 0.1(or http://tplinkwifi.net ), and the default login username and password both are admin (all lower case).

How do I reset my TP Link Nano?

Directly press and hold the RESET button on the rear panel/panel layout with a pin for approximately 6 to 10 seconds when the device is running. Release the reset button and wait for the device to reboot.

How do I connect two routers together?

Plug one end of the Ethernet cable to one of your primary router’s LAN (Ethernet) ports, and the other into to any available LAN port on secondary router. Restart both routers once connected. You can do this by unplugging each router’s power cable and plugging it back in a few seconds later.