What is the metal plate under the needle?

Throat Plate (5) This metal plate, sometimes called a needle plate, sits below the needle and presser foot. A small opening in the plate allows the bobbin thread to come out and the needle to pass through to make stitches.

Why is my needle hitting the plate?

The needle is not installed correctly. Make sure that the flat spot of the needle faces the back of the machine. 2. The needle clamp screw could be loose.

What is the metal plate on a sewing machine called?

The needle plate is the flat, metal plate under the needle that covers the bobbin. When you’re making stitches, the needle goes down through the needle plate. The needle plate has marks that act as seam guides. These allow you to gauge how far your stitches are from the edge of your fabric.

What is slide plate in sewing machine?

SLIDE PLATE: It is a rectangular plate which slides out easily. This facilitates the loading and unloading of the bobbin case into the shuttle. STITCH REGULATOR: This controls the length of the stitch. Higher the number longer the stitch length. The length of stitches varies according to the type of fabric.

Why is my needle hitting my walking foot?

There are several reasons why the needle keeps hitting the presser foot/needle plate: 1. The presser foot you are using may not be appropriate for the type of stitch that you want to sew. – Attach the presser foot that is correct for they type of stitch that you want to sew.

Why is my sewing machine needle off center?

As you loosened the set-screw; the presser bar may have dropped down to the needle plate because the set-screw was loosened a bit too much. Not to worry, we’ll reset that. Internally, within the two part presser bar, is a spring that will encourage the bar to drop.

What are the 20 parts of a sewing machine?

Functions of each sewing machine parts have discussed below:

  • Spool pin: The main function of the spool pin is to hold the spool of thread.
  • Bobbin binder spindle:
  • Bobbin winder stopper:
  • Stitch width dial:
  • Pattern selector dial:
  • Handwheel:
  • Stitch length dial:
  • Reverse stitch lever:

How do you attach a needle plate cover?

Attach the cover by inserting the two projections on the underside of the cover into the notches on the needle plate as shown below. To remove the embroidery needle plate cover, place your fingernail in the groove and lift the plate out. Push the embroidery needle plate cover as far as possible to attach it.

How do you remove a needle plate cover?

Insert the tip of the index finger of your left hand into the notch at the back of the needle plate cover. Place the thumb of your left hand at the front of the needle plate cover. Slide the needle plate cover toward you to remove it.