What is the maximum allowable tolerance when you do shaft alignment?

The “Acceptable” Offset shaft alignment tolerance for 1800 RPM is 4.0 mils.

Which type of coupling has an alignment tolerance?

Generally, flexible couplings are able to tolerate up to ±3 degrees of angular misalignment and up to 0.75 mm parallel misalignment depending on their design. If more misalignment is required, a universal joint can be used (see Figs. 4.18 and 4.19).

What is the general tolerance range for coupling alignment in inches?

– The coupling tolerance is 0.062” of offset, 0.01745” per inch of angle. – The ANSI standard is 0.006” of offset, 0.0012” per inch of angle.

How do you know if your shaft is aligned?

Shaft Alignment Procedures ( Rim and Face Alignment Method )

  1. Rotate the dial indicators to 12:00.
  2. Set the face dial indicator to zero.
  3. Record the setting of both dials at 12:00.
  4. Rotate the dial indicators to 3:00.
  5. Determine and record the reading on both dials.
  6. Rotate the dial indicators to 6:00.

How do you calculate alignment reading?

To measure vertical misalignment, perform the following steps:

  1. Rotate the dial indicators to 6:00.
  2. Set the face dial indicator to read zero.
  3. Set the rim dial indicator to the sag value.
  4. Rotate both shafts (if possible) to 12:00.
  5. Record the DIR and DIF dial indicator TIR values.

What is soft foot in alignment?

In his book, Shaft Alignment Handbook, noted alignment expert John Piotrowski defines soft foot as the condition “when rotating equipment is set into place on its base, frame or sole plate, one or more than one of the ‘feet’ are not making good contact at the foot points of the frame.” More generally, the condition is …

How do you align a coupling?

A coupling is correctly aligned if a straight-edge laid across both coupling halves parallel to the shaft maintains the same distance from the shaft at all points around its circumference. In addition, the axial distance between the coupling halves should remain the same at all points around the circumference.

What is axial misalignment?

3. Axial. An axial misalignment means the two ends of each axis, or shaft, don’t meet. They are parallel, but when fully extended, the ends do not come together. This kind of misalignment can also be called an end float because the ends of the shafts “float” but do not connect, meaning they can move in and out.

What is the maximum amount of soft foot permissible?

Soft foot can be measured a number of ways. Always start any soft foot measurement with all of the bolts securely tightened. As we go through the different methods, keep in mind that the industry standard for the maximum soft foot measurement is 2 thou (mils) or . 25 mm.

What are the four types of alignment?

There are four types of paragraph alignment available in Microsoft Word — left-aligned, center-aligned, rightaligned, and justified.

  • Left-Aligned Text. A paragraph’s text is left aligned when it is aligned evenly along the left margin.
  • Center Aligned Text.
  • Right-Aligned Text.
  • Justified Text.

What is a 16 point alignment check?

A “16-point check” has been the standard measurement method for verifying this coupling alignment. In its core form, it is like the “rim and face” check used in standard dial indicator alignment. The rim readings are measured by a dial indicator that indicates along the edge of the coupling.

What is bar sag in alignment?

Sag (also called bar sag) is the result of gravity acting on the overhung hardware spanning across the coupling that holds the indicator(s). It is always present, and its magnitude and repeatability must be accurately measured and known for the millwright to have any hope of measuring the misalignment accurately.

https://www.youtube.com/watch?v=e06RNIbxeyI