What is the difference between Redarc V2 and V3?

The V3 follows the previous version Tow-Pro Elite V2, which was named a 2017 Global Media Award winner at the SEMA Show. Enhancements to the upgraded Tow-Pro Elite V3 include size adjustments and greater ease of installation of the user interface (remote head) and compatibility with new vehicle technology.

How do I know if my Redarc brake controller is working?

To test your Tow-Pro Elite brake controller, connect a 21W globe between the earth pin (3) and trailer brake pin (5) of your trailer base. The LED should illuminate BLUE or GREEN depending in what mode it’s in. Once the remote head is GREEN, have someone watch the test light.

Why does my Redarc brake controller flash red?

To summarize this – the main things that are seen are either a poor connection to the earth return in the trailer plug or Anderson connections OR an under-rated cable on either the vehicle or van/trailer side.

Is Redarc Tow Pro compatible with Hydrastar?

Yes, the Redarc Tow-Pro Elite Trailer Brake Controller # RED44FR is compatible with electric over hydraulic actuators such as the Hydrastar # HBA16.

How much does it cost to fit a Redarc brake controller?

$495 Fully Installed mobile. The EBRH model Electric Trailer Brake Controller comes with the LED and controls to allow remote mounting up to 500mm away from the main unit. The controls are small enough to be mounted in the dash through a standard push-out switch panel.

Why is my Redarc flashing green and blue?

The green/blue flashing LED that is on displayed on the remote head indicates active calibration has not been completed.

Why is my Redarc brake controller flashing green and blue?

This is normal and the unit is in sleep mode. Breathing, as opposed to flashing, is the LED gradually getting brighter until its brightest point and then gradually dimming off. Whilst driving with the trailer connected, the LED indicator will flash blue and green. The Tow-Pro™ Elite will calibrate as you brake.

How long does it take to install Redarc Tow Pro?

about thirty minutes
Try watching this video on www.youtube.com, or enable JavaScript if it is disabled in your browser. As far as installation, both main control units are approximately the same size and install in the same way. With the right tools, installing the Tow-Pro takes about thirty minutes.

How much does it cost to fit a tow Pro Elite?

REDARC TOW-PRO ELITE V3 FITTED FROM $525.