What is the default password for APC PDU?

What is the default password for APC PDU?

what is default password for apc pdu? The default username and password for apc pdu is “apc”. It is a common username and password and can be used for setup and installation of APC Management Card setup, BOOTP and DHCP configuration, Local access to the control console among others.

What is a APC PDU?

APC Switched PDU APC Switched Rack Power Distribution Units (PDUs) enable advanced, user-customizable power control and active monitoring. Remote outlet level controls allow power on/off functionality for power cycling to remotely reboot equipment and restrict unauthorized use of individual outlets.

How do I mount APC PDU?

To install the Rack PDU using the toolless mounting method, install it in the rear of the NetShelter® VX or SX Enclosure, in the cable channel directly behind the rear vertical mounting rails. To install the Rack PDU using the mounting brackets, install it on a vertical mounting rail on your rack or enclosure.

How do I access APC PDU?

To access the Web interface and configure the security of your device on the network: 1. Address the Rack PDU by its IP address or DNS name (if configured). 2. Enter the user name and password (by default, apc and apc for an Administrator, or device and apc for a Device Manager).

How do I factory reset my APC PDU?

Resetting APC AP7920 PDU

1. Press and hold the reset button for about 10 seconds.
2. The status light should blink rapidly.
3. Release the reset button then press it again for about a second.
4. The light should go orange.
5. After about 20 seconds the reset will complete and the device will have booted.

What is the difference between a PDU and a UPS?

PDUs merely distribute power. They do not generate it. UPSs are essentially backup batteries in the server rack. They provide backup power in the event of an outage and complete protection against power quality problems.

Where do you put the PDU on a rack?

PDUs can be mounted inside your server rack wherever you need a source of power for your equipment. You can mount them vertically along the side rails or in the back of the enclosure, or horizontally within the rack, in the same space as a server.

How do I find my PDU IP address?

For PDUs with a display screen: Press and hold the select button for a few seconds. Once “IP” appears on the display screen, release the button. Your unit will then display the IP address in a sequence of four groups.

How do I find the IP address of an APC PDU?

Antaira UTS-1110A single-port USB to RS-232] serial adapter. Photo by Antaira. By default, the APC AP7900 does not have an IP address assigned. The easiest way to configure an IP address is to log into the PDU over a serial port….Old Firmware.

What is the default IP address for apc PDU?

systems, the switched PDUs have the IP address of ‘10.20. 2. x/255.255. 0.0’….Old Firmware.

How do I restart apc PDU?