What is the cost of STP?
What is the cost of STP?
Now, the NMC has estimated the cost of 120 MLD capacity STP (200 MLD but augmentation will be of 120 MLD) at Rs 297.60 crore. The cost of 1 MLD comes to Rs 2. 48 crore. However, a senior NMC official said that the project cost of STP will be around Rs 170 crore and remaining is operation and maintenance cost.
Are wastewater treatment plants expensive to operate?
It’s a fact. Operating a wastewater treatment plant is expensive. Much of that expense comes from the energy it takes to run it. But, with a little planning, there are some ways, outside of a full plant replacement, to save money on operating costs.
Why is wastewater treatment so expensive?
The main factors of wastewater treatment system cost All in all, there are two main factors that drive the cost of a wastewater treatment system: What is the quality (levels of contaminants) of the plant’s effluent and what are the local maximum and average monthly discharge limits to the environment or POTW?
How much does it cost to build a water treatment plant in Canada?
The cost to build a water treatment plant is estimated at $204 million.
How do you reduce STP costs?
The reduce life cycle cost of STP, and recover full value of water and sludge, consider treatment technology that has zero power consumption for primary treatment with Anaerobic technology followed by polishing with high efficiency aeration and lastly to ensure bacteriological quality compliance such that the treated …
Does STP stink?
Strong smell/odour from the STP: This is a very common complaint from numerous housing communities and even commercial buildings which have an STP in operation. The smell is often very strong and quite often unbearable.
How much does it cost to treat 1000 gallons of water?
water treated. The total cost of water treatment for the surveyed greenhouses ranged between $0.07 for chlorine gas to $1 per 1,000 gallons for copper ionization (Table 1). Labor was up to $0.03 per 1,000 gallons for all treatments, except ozone which required more skilled management than other technologies.
How much money does it take to build a water treatment plant?
Model results for unfiltered systems treating groundwater The chart shows that the estimated average annual O&M cost for plants producing 100 ML is $63,000, with the true value falling between $52,000 and $76,000 (with 95% confidence).
Who pays for water treatment plants in Canada?
In addition to delivering support for provincial, territorial and municipal water and wastewater priorities, the federal Government will fund up to 50 per cent of eligible costs for projects. This Fund is improving the safety and quality of water for Canadian families, while supporting a clean economy.
Why should an STP not be in a basement?
It needs to be installed in the premises in a location where it is above ground and hence can get all the air it needs for it to function and to facilitate easy maintenance. Never install an STP in a basement. Almost all STPs in multi storied apartment complexes are installed as deep underground as possible!
