What is the command to check Vserver?

To determine the available languages, enter “vserver show -language? ” at the clustershell command prompt and at the Vserver prompt. If this parameter is specified, the command displays information only about the Vserver or Vservers that have the specified Snapshot policy.

How do I start Vserver?

A Root VServer can be restarted via the Cockpit. Navigate to the corresponding detail page of the VServer and click the “Actions”-Button. You can then select to start, stop or restart it.

How do I see volumes on Netapp?

To display detailed information about a single volume, run the command with the -vserver and -volume parameters. The detailed view provides all of the information in the previous list and the following additional information: Name ordinal. Volume data set ID.

What is Vserver in netapp?

Manage Vservers. The vserver commands enable you to manage Vservers and their attributes, including the configuration of the CIFS and NFS protocols, export policies, name mappings between CIFS and NFS users, and network services.

How do you add volume on Netapp?

  1. Create an aggregate.
  2. Decide where to provision the new volume. Create a basic SVM.
  3. Create and configure a volume.
  4. Create a share and setting its permissions.
  5. Create an export policy for the volume.
  6. Verify SMB client access.
  7. Verify NFS access from a UNIX administration host.
  8. Configure and verify CIFS and NFS client access.

What are LIFs?

A LIF (logical interface) is an IP address with associated characteristics, such as a role, a home port, a home node, a routing group, a list of ports to fail over to, and a firewall policy. You can configure LIFs on ports over which the cluster sends and receives communications over the network.

What is LUN in netapp?

A LUN is a logical representaion of storage. It looks like a hard disk to the client. It looks like a file inside of a volume. You can see the Data ONTAP ‘Block Access Management Guide for iSCSI and FC’ for documentation. Its rough but pretty straight forward.

What is difference between volume and LUN?

A LUN is a logical volume from the point of view of the storage. From the client point of view the LUN it is a disc volume that can be partitioned. Volume is a generic term. It means a contiguous storage area.

How do I create a root volume in netapp?

Steps

  1. Identify an existing volume to use as the new root volume, or create the new root volume by using the vol create command.
  2. Use the ndmpcopy command to copy the /etc directory and all of its subdirectories from the current root volume to the new root volume.

What is a LIF or Lrif?

Share on. Life income funds (LIFs) and locked-in retirement income funds (LRIFs) are tax-sheltered accounts used to pay out the accumulated value of a locked-in RRSP, locked-in retirement account (LIRA) or locked-in amounts under a registered pension plan (RPP).