What is SikaTop Seal-107?

DESCRIPTION. SikaTop® Seal-107 IN is a two part acrylic polymer modified cementitious liquid applied waterproofing coating system. It comprises of a liquid polymer and a cement based mix incorporating special admixtures. It is applied to concrete and mortar to prevent water in- filtration. USES.

How do you use cementitious WaterProofing?

Steps Involved in WaterProofing

  1. Step 1: Surface Preparation. Clean the surface thoroughly free from loose materials, dust, and oil.
  2. Step 2: Application of Primary Coat. Ad.
  3. Step 3: Unrolling the Membrane Sheets.
  4. Step 4: Heating the Membranes.
  5. Step 5: Pressing the Membrane.

How do you mix Sika waterproofing?

Place the correct amount of clean water into a mixer and add the mortar and mix until the water has been evenly dispersed, approximate 3 minutes. The Sika®-1 Mortar Waterproofing System mortars should be mechanically mixed using a forced action mixer or drill and paddle mixer to limit the amount of air entrap- ment.

How much is Sika top seal 107?

91147 SikaTop Seal 107 Flexible, Waterproofing, Polymer-Modified, Cementitious Coating, Gray, 2.65 Gallon [SIKA-91147] : Cementitious Coatings – $80.95 EMI Supply, Inc.

How waterproof is step by step?

  1. Step 1: Check surface adhesion.
  2. Step 2: Clean work area.
  3. Step 3: Apply corner pieces.
  4. Step 4: Apply tape for corners and edges.
  5. Step 5: Waterproof plumbing fittings.
  6. Step 6: Apply membrane on walls.
  7. Step 7: Correction and finishing.
  8. Step 8: Apply membrane of floor for bathroom sealing.

Can you add Waterproofer to concrete?

With Cementmix any kind of cement, mortar or concrete, can be waterproofed, made water repellent and stop rising damp.

How long does Sika waterproofing take to dry?

It is recommended that a Cem I 52.5R or N is used for best results. Protect from wind and direct sunlight for at least 24 hours after application. For continuous submersion applications, allow the treated surface to cure for at least 48 hours before submerging. The concrete substrate must be sound.

How do you apply Thoroseal waterproofing?

Start at the top and work down. Use a tampico fiber brush to apply Super Thoroseal® in a thick coat, working the mixture into the pores of the surface for a good penetrating seal. Double back and use the brush to smooth out the material. Allow 12 hours between coats for drying time.