What is a J clip nut?

A J-nut is a sprung clip that snaps onto a sheet to provide a nut. J-nuts are a type of clip-on nut, similar to U-clips or U-nuts. Unlike U-nuts, however, J-nuts have one leg that’s shorter than the other. Other types of clip-on nuts include cage nuts and S-nuts.

What is a speed nut clip?

A speed nut, aka sheet metal nut or Tinnerman nut, is a type of locknut with two sheet metal prongs that act as one thread. They are made from spring steel.

What is a retainer nut?

Nut Retainers are self-retaining spring steel fasteners that have a bolt-receiving nut floating inside a cage that off-sets normal hole misalignment and doesn’t turn when the bolt is tightened.

What is a jack nut?

Jack nuts are a unique type of threaded fastener, specially designed for use with light duty, thin, or brittle material. When installed, the body of jack nut collapses on the back (blind) side to form “legs” which provide a sturdy grip on the inside of the mounting service.

What does AJ nut look like?

J-nut. A J-nut is a nut that clips to the edge of the sheet metal. It is named after the way it is shaped; the thread is on the long side of the “J”. The thread may either be of a speed nut form or have an integrated hex or square nut.

How do you remove clip nuts?

Break the push nut with a screwdriver or chisel. One way to remove a push nut is by inserting the top of a sharp flathead screwdriver or a chisel between the teeth of the push nut and the bolt. Pry the teeth of the push nut up until they bend or break, allowing the push nut to be removed from the bolt.

What is a push nut?

Pushnuts are a simply applied push on fastener ideal for retaining components to shafts, tubes and studs. Push nuts are a time-saving cost-efficient fastener. So secure that the pushnut cannot be removed without destroying the fastener.

What are Jack nuts?

What is a well nut used for?

A well nut, also called a rubnut, rubber nut or rawlnut, is a fastener used when something needs to be connected to a surface (in most cases where only one side is available). Installing well nuts is a simple task: A hole must be drilled into the installation material.