What does DMS fault mean?

Code 49 – “DMS Fault” If an input device shows out of center, that device needs to be replaced. If an input device is not out of center they can check to see if they have the latest firmware pack.

How do you unlock a quantum wheelchair?

Press the Horn Key twice during the 10 seconds (approximately) that the indicator LEDs are scrolling. The controller is now unlocked. Hold On/Off Key until beep, then release. Push Joystick forward until beep, then pull Joystick back until beep.

How do you turn off the lights on a quantum wheelchair?

1. Turn off the power to the controller OR press the single switch. NOTE: If the single switch is used to turn off the lights, the single switch must be used to turn the lights back on before the lights will operate through the controller.

How do you change the speed of a quantum wheelchair?

1. Push the On/Off and Mode Select Lever up once to power on the chair and the controller. 2. To increase your speed, turn the speed adjustment knob up.

Why is my electric wheelchair not working?

Check to make sure all battery connectors are properly connected. Verify the batteries are fully charged. If they are not, proceed with charging. If batteries still won’t charge properly, replacement batteries might be needed.

How do you reset a power wheelchair controller?

Make sure the joystick power is on and follow the process:

  1. Move the joystick forward and hold it until you hear a beep.
  2. Then move it in reverse and hold it until you hear a beep.
  3. Release the joystick, and you will hear another loud and long beep.
  4. The flashing light will indicate that the power chair is unlocked.

How do you charge a dead wheelchair battery?

Plug the off-board charger into the off-board charger/programming socket on the controller. Plug the off-board charger into the electrical outlet. When the batteries are fully charged, unplug the off-board charger from the electrical outlet and then from the controller.

Can I make my electric wheelchair go faster?

If you want to increase the speed of your electric mobility chair, you should perform routine maintenance and follow your manufacturer’s recommended suggestions. Use a damp sponge to remove buildup and debris from the axles. Any type of obstruction can hinder the performance of your chair.