What are the safety rules for a bandsaw?
What are the safety rules for a bandsaw?
What safety procedures should you follow when using a band saw?
- Wear safety glasses or goggles, or a face shield (with safety glasses or goggles).
- Wear hearing protection that is suitable for the level and frequency of the noise you are exposed to in the woodworking area.
- Wear protective footwear when required.
When operating a bandsaw Which of the following is a safe practice?
Keep guards in place at all times. The blade guard should be from 1/8 to ΒΌ inch above stock. Keep hands away from blade and do not open upper or lower bandsaw doors while blade is in motion. Maintain a balanced stance and keep your body under control at all times; do not overreach.
What are the hazards of a bandsaw?
If a blade is dull or has teeth missing, the material being cut can judder or kick back. These risks can result in serious injuries, including amputations and severe cuts. Bandsaws can also create airborne contaminants such as vapours, gases and especially dust.
Does OSHA require guards on table saws?
Each circular crosscut table saw shall be guarded by a hood which shall meet all the requirements of paragraph (c)(1) of this section for hoods for circular ripsaws. Circular resaws. Each circular resaw shall be guarded by a hood or shield of metal above the saw.
What are three 3 safety rules to follow when using the bandsaw?
Safety Rules Safety glasses are required. Never clear small pieces while blade is moving. Never adjust saw or setup while saw is running. Never cross arms.
When using a bandsaw the operator should avoid?
Never start the machine with stock touching blade, never reach under the table, and never perform layout or setup on the table. 12. Turn machine off and disconnect from power source before installing or removing accessories, when finished cutting, before adjusting or changing set-ups, or when making repairs.
What is the most important point of safety when using a band saw?
Always keep your hands on the sides of the blade while operating…. never in front of blade! 10. Maintain a well-balanced position and feed work into blade firmly, but without pushing too hard.
Do band saws have guards?
The band saw safety guard can mount to the front door using the supplied bracket, or side of the upper housing. Slotted aluminum allows adjustment in/out and up/down to clear the work-piece and guard the vertical band saw blade at different heights.
Which OSHA standards cover woodworking machinery safety?
29 CFR 1910.213(a)(4), Woodworking Machinery Requirements | Occupational Safety and Health Administration.
How many inches away from the blade should your hand be a minimum away?
12. Keep hands out of the path of the saw blade. NEVER CUT A PIECE WHERE YOUR HAND WOULD BE 6 INCHES OR LESS FROM THE BLADE. Find a safe way to secure the work as it must be held down to the table top and Page 3 against the fence during the entire cutting process.
