How to use throttle valve cleaner?

Follow the plastic duct from the air filter housing up to the throttle body. Remove the duct and locate the throttle cables and rotating mechanism. Rotate the throttle mechanism and spray the cleaning solvent around the inside of the throttle body. Give it a moment to work and then wipe out the crud.

How do you use line pro Liqui Moly?

Incorporating LIQUI MOLY Pro-Line Engine Flush in oil services will, among other benefits, lower oil consumption and increase performance. Simply pour it in a warmed-up engine, turn on the car and let it idle for ten minutes, then turn the car off, and proceed with the oil change.

How do I get rid of carbon build up in my throttle body?

Open the throttle blades with the throttle control. Wipe the inside and outside of the throttle blades carefully but aggressively enough to remove carbon build-up. Continue to add throttle body cleaner if the rag begins to dry or there is excess carbon build up.

Does Liqui Moly flush work?

After one use the engine was significantly cleaner, and it took a couple weeks before the oil was dark black again. Another 2500 miles later I used it once more, and now my oil almost looks new at 5000 miles. I’d say one more use and I’ll be good to go for quite some time. Very happy with this product!

Can I drive with Liqui Moly engine flush?

Can I leave engine flush in my oil whilst I am driving it until my next service? No, never leave an engine flush in the engine with the new oil. It is not designed to be like an additive to the oil. It MUST be removed before you drive the vehicle off from the workshop or your garage.

Should I use Liqui-Moly valve cleaner on my Honda CRV?

After having such a great experience using the Liqui-Moly valve cleaner in my diesel truck, I decided to try their products on my 190,000mi Honda CRV. I first ran a full tank with the injector cleaner and thought it ran slightly smoother, but not much.

How do you clean the throttle valve on a Honda Accord?

Spray the Throttle Valve Cleaner across the entire area of the throttle valve in intervals of 2 – 3 seconds at min. 2,000 revolutions via the spray probe. If the engine cannot maintain the speed with the intake pipe removed or cannot be started, disconnect the plug from the air flow meter with the ignition switched off.

How to clean the intake manifold of a diesel engine?

In the case of stubborn deposits on the throttle valve, in the intake manifold or on the intake valves, cleaning can be repeated with a second can. After use, allow the engine to run for about 20 seconds at min. 2,000 revolutions in order to burn any residues remaining in the intake system.