How to fix HP LaserJet P2015 paper jam?

Answer/Solution The HP LaserJet P2015 may come up with Paper Jam Light solid ON and would show the same light pattern even if the printer is power cycled. Press and hold the GO button on the control panel of the printer. Turn on the printer and continue to hold the GO button for at least 50 seconds.

How do I reset my HP LaserJet p2015d?

Use the following procedure to perform a network reset.

  1. Turn off the printer.
  2. Press and hold the Job Cancel button.
  3. Turn on the printer and continue to hold the Job Cancel button for approximately 10 seconds, but no longer than 20 seconds.
  4. Release the Job Cancel button.

How do I clean HP LaserJet 1320?

Select “Printing Preferences” and then “Printer Services” or “Printer Utility.” Access “Printer Alignment, “Nozzle Check” or “Print Head Cleaning” utilities and follow the instructions that will appear on your screen to complete each process.

How do I use my HP laser printer?

HP LaserJet Pro, Ultra Printers – First Time Printer Setup

  1. Step 1: Remove the printer from the box. The contents might vary by country/region.
  2. Step 2: Load plain paper in the main input tray.
  3. Step 3: Connect the power cord, and then turn on the printer.
  4. Step 4: Set your preferences.
  5. Step 5: Install the printer software.

What causes printer jams?

Improperly Loading Paper into the Device Loading paper that is stuck together, frayed, curled or bent can cause a jam. Overloading the paper tray, loading different thicknesses of paper in the tray or using paper that isn’t appropriate for your particular printer can all result in a jammed printer.

Should I turn off my HP laser printer when not in use?

Always best to leave the printer on and left it go into sleep mode. Otherwise every power up will perform a maintenance cycle using some ink.

What are the 7 steps of the laser printing process?

The Seven Laser Printing Steps

  • Step 1: Sending. To begin the laser printer process, the document is broken down into digital data and sent from the respective computer to the printer.
  • Step 2: Cleaning.
  • Step 3: Conditioning.
  • Step 4: Exposing.
  • Step 5: Developing.
  • Step 6: Transferring.
  • Step 7: Fusing.