How much oil does a super T10 hold?

actually it`s easier with your pinkie… Buy two quarts and you will use about a quart and a half…it`s full when you stick your ‘pinkie’ in and the tip is wet from gear lube….

How much oil does a T10 take?

You fill it until the oil runs back out the filler hole. If the transmission is not in the car make sure that it is sitting up-right in the proper position. You will need a bout 2 quarts of oil if it is empty.

How much oil does a Borg Warner take?

Oil capacity: 5 US quarts (4.9 liters).

What oil does a t19 transmission take?

The recommended lube now is SAE 50 motor oil.

How do I know if I have a Super T10 transmission?

Look for casting identification on the transmission casing. According to Drivetrain.com, the “T10” designation and the code, “13-04,” is sometimes cast on the transmission housing. Count the cross-grooves on the input shaft. The input shaft enters the engine at the front of the transmission.

How much oil does a Muncie 4 speed hold?

I believe a Muncie 4 speed holds about 2.5 pts. Fill the trans till you can feel oil at the bottom of the fill hole. I believe the GM shop manual now recommends 80W-90 GL-5.

How do you check transmission fluid in a Marine?

Basically, you run the engine for five minutes at idle, shift a couple of times, shut down, then pull the dipstick and check the fluid level. Don’t wait long after shutting down, lest fluid in the cooler drains back into the transmission, which then causes an erroneous “overfull” reading.

What cars came with Super T10?

Ford installed it in their full-size models (both Ford and Mercury), Mustangs, Falcons, Comets and Fairlanes until ’65. AMC continued to use it in their Javelin and AMX cars until ’74.

How much does a super T10 weigh?

A dry weight Super T-10 weighs 70 lbs while a dry weight Turbo 350 weighs 120 Lbs. The super T-10 takes about 1.5 quarts of gear oil while a Turbo 350 takes 11-12 quarts of automatic transmission fluid.

Can you use GL 5 gear oil instead of GL4?

GL5 and GL4 have similar properties and they have a decent amount of additives to enhance their extreme pressure rating. You can use GL5 instead of GL4, though it does not mean you should. For the best performance of your vehicle’s transmission system, use the recommended oil type.

What is a Borg-Warner T-10 transmission?

The Borg-Warner Super T-10 transmission is a heavy-duty, four-speed manual transmission that was designed for use in high-powered muscle and sports cars. From 1974 until 1982, Borg-Warner produced the transmission for GM’s A-body and F-body sports cars.

What kind of lubricant should I use in my Super T10?

And a Super T-10 equipped new performance car last rolled off the assembly back in the early-1980s. This was long before the widespread use of synthetic lubricants. This is why using a good conventional GL-4 lubricant is imperative.

What is the difference between a T-10 and a Super T10?

The Super T-10 featured a large, 26-spline input shaft, as compared to a smaller 10-spline input shaft of the original T-10 transmission. According to a 2008 article published in Hemmings Motor News, the Super T-10s “were built to withstand the higher rpm requirements for the larger muscle car engines.”

What would happen if you put GL5 in a Super T10?

what would happen with using GL5 in a Super T10? GL5 oils have additives that corrode the brass syncronizers in Muncies, Borg Warners, and Saginaws. (You must log in or sign up to reply here.)