How much does it cost to replace a BMW drive shaft?

Usually, the Drive Shaft Repair costs will differ based on what caused the issue and how fast it can be repaired. If you just have to replace it, that would be anywhere from $500 to $1000. However, you can also expect the cost of the parts to be around half that number and the labor costs around $200.

How much is it to replace a drive shaft?

In most cases, a new drive shaft costs somewhere between $300 and $1300. Fortunately, it only takes about an hour to replace it. A repair usually costs much less, around $200 to $300 including parts and labor, but this also depends on how many parts need to be replaced.

Is a drive shaft easy to replace?

Changing a drive shaft is actually a simple task that a home mechanic can undertake without too much trepidation. It’s just a case of being thorough, being safe, and of course having your trusty Haynes Manual to hand.

How long does it take to change a driveshaft?

In terms of labor, it should not take more than two hours. In most cases, it takes about an hour to replace a drive shaft. This means the total cost will be around $400 to $1500 including labor and parts. You could save a few bucks by replacing the driveshaft yourself as it is not a very difficult process.

Can you change a driveshaft at home?

How hard is it to replace a driveshaft?

Replacing a driveshaft is usually a relatively straightforward affair if you have the tools and the know-how. A driveshaft is a long shaft comprised of tubes, joints, and (in some cases) a center support bearing.

How long should a drive shaft last?

about 75,000 miles
If you allow the driveshaft to die completely, then it will reach the point where the wheels no longer receive any power. While there is no set lifespan of a driveshaft, it typically can last about 75,000 miles. Keep in mind depending on the vehicle, and wear and tear you may get much less or much more.

Can you change a drive shaft yourself?

If you have no knowledge of vehicle technology and no experience, a specialist workshop is the right choice. However, if you have a well-equipped private workshop and can also use a lifting platform, there is nothing to prevent you from changing the drive shaft yourself.