How long should my arrow shaft be?

Most new arrow shafts measure 32 inches before being cut, so that’s about as long of an arrow as you can shoot. Depending on your draw length, such an arrow might stick out an awful lot in front of your bow at full draw, which raises issues about clearance and maneuverability.

How do you measure arrow shaft length?

Correct arrow length is measured from the bottom, inside of the nock groove (deepest point where the string goes into the nock) to the cut end of the shaft, not including the point or point insert.

How long should my arrow be if my draw length is 29?

it depends on the arrows you choose, you need at least 1/4″ of arrow overhang on the rest. so you can probably shoot an arrow that’s about 28 1/4 for rests that are set up normally. and go all the way up to full length 36″ arrows for indoor.

Should arrow length be longer than draw length?

The best safety practice is to make sure your arrows sit at least 1″ beyond your arrow rest when the bow is at full draw. A little bit of extra arrow length gives the arrows an important margin of safety. A little too long is okay. A little too short is not.

How long should my arrows be for a 27.5 inch draw?

It really depends on you, some like them flush with the front of the riser, some like them just past the rest and as short as possible. I have a 27.5-28″ draw and my arrows are typically 27.75″. I wouldn’t want that long of an arrow personally. If you decide you want a heavier tip you will want a stiffer arrow.

How do you determine your draw length?

To measure your draw length, stand with your back to a wall stretching your arms out against the wall. Measure the distance from the end of your middle finger to the end of your other middle finger, basically the length of both arms, hands and chest. This measurement, minus 15 then divided by 2, is your draw length.

How long should arrows be for 27.5 in draw?

How long should arrows be for 26.5 draw?

The arrow must be 29″ in length and supported by two points, which are 28″ apart. The number of inches the arrow deflects or bends due to the weight, is the spine size or measurement of an arrow.

How long should my arrows be if my draw length is 27?

The arrow must be 29″ in length and supported by two points, which are 28″ apart. The number of inches the arrow deflects or bends due to the weight, is the spine size or measurement of an arrow. DYNAMIC spine describes the way an arrow reacts from the stored energy of a bow as it is shot.

How long should my arrows be if my draw length is 28?

around 27 inches
If you’re a 28-inch draw length and want an arrow that ends at the front of the riser, your arrow length would be around 27 inches. However, your arrow length can be longer if you need to weaken the spine of your arrow. For safety reasons, your arrows shouldn’t be cut too short.