How long does Resiblock take to dry?

RESIBLOCK SUPERIOR NATURAL MATT will normally be touch dry in about an hour, and cure sufficiently in 3-6 hours (20oC) to accept foot traffic. Full chemical resistance is achieved over 1-2 days.

What is the best product to seal block paving?

Polyurethane Block Paving Sealer (Solvent-Based) We recommend polyurethane sealants above all due to their long-lasting performance. This is the most rigid resin available for patio paving and block paving, and solvent-based sealers will lock in the quality even further.

Is block paving sealer worth it?

By sealing your block paving it will increase your block paving and patio’s life span. If you put the best type of sealant in place, your block paving and sealant could last for years to come. Not only will it increase the life span, but it’ll also contribute to other benefits such as: Reduce mould growth.

How long does paving sealer last?

How often should paver sealer be reapplied? The basic rule of thumb is every 3-5 years. For film-forming sealants, you will be able to notice when the physical barrier is showing signs of wear.

Can you spray Resiblock?

By brush, roller, spray or squeegee (STIR WELL BEFORE USE) generally the paver type will dictate the most appropriate application tool. Ensure sand filled joints are fully flooded with RESIBLOCK TRADE.

What is the best way to stop weeds growing through block paving?

White vinegar is readily available, cheap, and an effective weed killer for block paving. It dries out weeds on contact – you can use white vinegar on younger weeds or vinegar with a higher concentration for older weeds, such as weed killer vinegar, which can be picked up at any garden shop/supermarket.

How can I make my block paving look good?

On dry paving use a stiff bristled brush to remove any dirt or build up from the surface.

  1. Pull out, scrape off any weeds and moss.
  2. Using soapy water (basic washing-up liquid or a non-acid based detergent will suffice) and a stiff bristled yard brush, scrub the paving surfaces and hose down with clean water.

How do I stop weeds growing in my block paving?

Can you pressure wash block paving?

Yes, a jet washer will remove any dirt and moss covering your slabs, but it could also dislodge the sand. If you do use a power washer, it’s generally recommended that you angle it at 45 degrees, which reduces some of the pressure on the sand. You can still expect a good few inches of top sand to come off, however.