How does an up flush toilet work?

The primary difference between the two is that, while traditional toilets flush gravitationally, down into the drain, an upflush toilet discharges out the back, into a macerator and pump tank, which shreds the waste, then pumps it up, straight to your existing stack.

What is the flush on a toilet called?

Toilet flapper: Situated at the base of the tank, this lifts and triggers a flush of water to the toilet bowl. It is also called a flapper valve. Toilet lever: Connected to the handle, this lever lifts the rubber flapper, which triggers the flush. It is also called the lift rod.

What are the parts of a flush toilet?

Understanding the Parts of a Toilet

  • Bowl.
  • O-Ring.
  • Flange.
  • Wax Seal.
  • Handle.
  • Float.
  • Chain.
  • Flapper.

What is the difference between bottom inlet and back entry?

The entry (or inlet) is where the water enters the toilet cistern. A bottom entry toilet has a tap on the wall under the cistern, on either the right or left hand side of the toilet, and it connects to the bottom of the cistern. A rear entry toilet connects inside the cistern.

Can you plunge a Upflush toilet?

A macerator grinds solid waste into small enough particles that it can travel through your other waste pipes. Because of this, if you get a clog or blockage in your Saniflo, you cannot simply plunge the toilet to unblock it or you may damage the macerator. Instead, take apart the system and manually clean it.

What is the back of toilet called?

tank
The back of the toilet is called the “tank.” The tank is where water is retained so that users can engage the flushing mechanism after they have finished using the toilet.

What is a flush valve?

The flush valve, located in the middle of the toilet tank, includes the overflow tube, the hole where water enters the bowl when the toilet is flushed and the rubber tank ball or flapper that covers the hole when the tank is full. A broken flush valve prevents your toilet tank from forming a seal to hold water.

What are the parts inside a toilet tank called?

There are really only two main toilet tank parts: The toilet flush valve, which lets water gush into the bowl during the flush, and the fill valve, which lets water refill the tank after the flush. When a toilet runs constantly or intermittently, one of these valves is usually at fault.

What is BTW toilet?

A back to wall toilet is where the pan is fitted fully to the wall or against a specially designed cistern unit. The cistern and all plumbing work is hidden in the wall or the unit, which provides a much neater finish to your bathroom.

What is the difference between P and S-trap?

Both types of traps are intended to do the same thing, which is to provide a water barrier between the inside of your home and the sewer. P-traps were designed to eliminate the main issue with s-traps, which is that they tend to siphon away too much waste water, leaving the drain “dry”.