How do you troubleshoot a table saw?

The first place to look for a problem when a table saw won’t start is the power cord, especially if the saw is portable, because the plug may be loose. If pressing the red reset on the motor — which is a thermal overload switch — doesn’t restore operation, then the breaker may have tripped.

Why is my table saw not working?

A failed power supply, broken on/off switch, bad motor overload, broken power cord or failed drive motor can prevent the table saw motor from starting. First, try resetting the overload. If the table saw motor won’t start after resetting the overload, then the saw may not be getting power from the electrical outlet.

Why does my table saw keep cutting out?

Worn motor brushes, a bad drive motor, a faulty motor overload switch, using an improper extension cord and binding up the saw blade can cause the table saw’s motor overload to trip.

Is the Delta 36 725t2 belt driven?

This is a BELT DRIVEN machine that offers low vibration and easy tensioning. A unique tubular stand with two fixed wheels and one swivel wheel makes the saw very stable and easy to move.

How do you reset a Delta table saw?

Most of the Delta’s have a reset button on the motor, usually a nice bright red. The real clue in your post was cutting 8/4 hard maple. Yup, push it a bit too hard or cut with a duller blade and the motor will trip to protect itself from you. indeed you are both right!

Why does my table saw bog down?

Overfeeding refers to forcing a piece of lumber or wood through your table saw blade at too rapid a pace. This will cause the blade to bog down, the motor to scream, and a violent kickback. Going slower is better when using table saws as you can control the cut better while maintaining a better degree of precision.

Why does my table saw blade smoke?

A Dull or Dirty Saw Blade Might Be the Culprit Pushing the stock through the saw too slowly is a common cause of saw blade burn. Sometimes a blade that feels dull might only be dirty. If wood pitch resins build up behind the teeth of the blade, the cutting speed will slow down, increasing the chances for burns.

Where are Delta saws made?

Chang Type is moving Delta’s production tooling from a Stanley Black & Decker owned facility in Jackson, Tennessee to a facility in Anderson County, South Carolina. Most recently, Delta has purchased an improved facility in Spartanburg, SC and has moved all operations to this location.

Does a Delta table saw have a reset button?