How do you transfer pictures to ceramic tile?

Cut your photo so that there’s minimal white space around the edges. To prep the tiles, wipe with a damp towel to remove any dust. Brush a light coat of Mod Podge on both the tile and on the photo (the front of the photo, NOT the back). Place the photo onto the tile, taking care to line up the photo with the tile.

How do you make coasters out of old photos?

How to Make DIY Photo Coasters

  1. Step 1: Paint the edges of the tiles.
  2. Step 2: Trim your photos down for your DIY photo coasters.
  3. Step 3: Glue photos to center of tile.
  4. Step 4: Prepare the resin.
  5. Step 5: Spoon out resin onto your DIY photo coasters.
  6. Step 6: Repeat for each tile.
  7. Step 7: Get rid of the little bubbles.

How do you make photo coasters waterproof?

You’re going to want to coat the image and coaster with at least three coats of Mod Podge, allowing it to dry for 15 minutes (or until clear) between coats. Once the final coat has dried, spray all of the coasters with a clear acrylic gloss spray, which ensures that they’re waterproof/drink proof.

How do you put pictures on a ceramic plate?

Place the cutout image in a bowl of water for about 30 seconds. The backing paper will curl as the decal loosens from the paper. Remove the cutout before it’s completely released and slide it off the paper onto the plate. You can slide the image into position on the plate while it is still very wet.

How do you Mod Podge pictures onto tile?

Paint a thin coat of Mod Podge onto a tile. Lay the photo onto the tile, centering it and smoothing out all of the air bubbles. Wipe away any Mod Podge that comes out the edges. Repeat with the other tiles and photos.

How do you seal photo coasters?

What do I use to seal tile coasters?

Varnish. Varnish is an excellent material for making coasters waterproof because of its chemistry. It contains a high ratio of solids compared to other finishing solutions. You can use spar varnish to protect wood and other materials, and it’s perfect for waterproofing.

How do you Modge podge pictures on ceramic tile?

This is much easier on wood or canvas because they’re porous, but it can be done on tile!

  1. Print out or get a photo copy of your picture.
  2. Coat the picture with Mod Podge and lay face down on the tile.
  3. Let dry; thoroughly.
  4. Spray the paper with little amounts of water and GENTLY start rubbing the paper off.