How do you reset a Vokera compact he?

To reset the appliance, make sure the gas supply is on to the appliance. Turn the mode selector switch to the OFF position for a few seconds and then turn it back to its previous position. If the red LED stays on or is illuminated after a few seconds call an engineer.

Why is my Vokera boiler not working?

There are many possible reasons why a Vokera boiler will fail to ignite: faulty ignition leads or electrode (needed to make the spark to create the flame), blocked flue or condensate pipe, issue with the gas valve or a printed circuit board (PCB) fault.

Why is my boiler not firing for hot water?

A boiler might not ignite due to various possible reasons – insufficient pressure, blockage in the burner, faulty valves, frozen pipes etc. Sometimes, you can fix the problem on your own. In other cases, you don’t have any choice but to call an engineer.

How do you reset a Vokera boiler?

To reset your Vokera boiler, move the mode selector switch to the ‘OFF/RESET’ position and then move it back to either ‘hot water only’ or ‘heating and hot water’. Should this reboot get your boiler working again then you’ll know because there will be a constant green light.

Where is is reset button on Vokera combi boiler?

If you want to reset your Vokera boiler, you need to move the mode switch to the ‘OFF/RESET’ position and then back to either ‘hot water only’ or ‘heating and hot water’. There will be a constant green light if the boiler gets working again.

What does a red light mean on a Vokera boiler?

#1 – Red Light On, But Green Light Is Off A fan that doesn’t fire up during the start-up sequence, so the boiler is unable to expel flue gases. The pump isn’t circulating hot water, so hot water stays in the heat exchanger. The high limit thermostat has caused a lockout – your boiler is overheating.

Why is the light flashing on my boiler?

When your boiler displays a ‘C’ on the boiler screen and the burner light is also flashing, this means your boiler has reached the programmed temperature. If your house has not met the set temperature and your boiler is showing this it could be caused by a circulation problem in the system.

Why is my heating on but no hot water?

In the case that your radiators are heating up but there’s no hot water coming from the taps, then the most likely cause is a broken diverter valve. Combi boilers are fitted with a diverter valve, that opens and closes depending on whether hot water needs to be sent to the radiators or taps.

What to check when there’s no hot water?

6 Things to do When Your House Has no Hot Water

  • Check the thermostat settings. Many manufactures set the thermostat to 140 degrees Fahrenheit by default.
  • Check the circuit breaker.
  • Check the pilot light.
  • Check for leaks.
  • Flush the tank.
  • If all else fails: Upgrade your hot water heater.

Why is there a red light on my boiler?

Usually, when modern boilers need resetting they will display a fault code or begin to flash a red or green light. These signals indicate that your boiler senses a problem, which is why it has stopped working and needs to be reset.

What does a green flashing light mean on a Vokera boiler?

Flashing green lights When the green light is constantly on it means the flame is working, but a flashing green light could be due to a faulty hot water sensor or because it is in standby. A reset may be enough but if not you may need to get in touch to arrange an engineer to diagnose the issue.