How do you program an old hunter thermostat?

Step 2: Program the HEAT Setting

  1. Slide the SYSTEM SWITCH button to the HEAT setting.
  2. Press PROGRAM.
  3. Use the UP/DOWN arrow keys to select the hour you want the first program to begin.
  4. Press the PROGRAM key again.
  5. Use the UP/DOWN arrow keys to set the minute you want the first program to begin.
  6. Press PROGRAM again.

How do I reset my hunter digital thermostat?

Press and hold the Programs button, and at the same time press in the recessed Reset button with the tip of a ballpoint pen. Release the Reset button and continue holding the Programs button until the Reset Memory screen appears (then release the Programs button).

What does a flashing 4 mean on a Hunter thermostat?

4. Indicates if the fan is set to Auto or On modes. 5. Allows you to switch between Heat, Cool, and Off modes.

Why does my hunter thermostat change by itself?

Solution: Switch out your batteries. It can be as simple as switching out the batteries on your thermostat device. This could also be the reason your screen can go blank sometimes. Thankfully, most thermostats should tell you when the time comes to replace them.

How do I reset my hunter 44110 thermostat?

You will need to reprogram if you hold the reset button down for 5 seconds and use a small pin or paperclip. If you did that. Press hold twice and hold the temperature until you change it.

How do you troubleshoot a hunter thermostat?

If the thermostat is failing to activate the air conditioner or heating unit as desired, first be sure the selector switch is in the correct location. If you are still having problems, turn off power to the thermostat, remove its faceplate and confirm that the wires are connected to the proper terminals.

What does a 3 mean on a Hunter thermostat?

5 The thermostat will flash 1,2,3 or 4 depending on its time and temp setting. A flashing 3 means the third setting is currently operating the heater or AC.

Why does my thermostat keep going up and down?

Q: What does it mean when your temperature gauge goes up and down? This simply means that your engine is overheated. An overheated engine can be caused by several factors. These factors may include leakage in the coolant level, a clogged radiator hose, a defective thermostat, a bad water pump, and failed radiator fan.

What does a flashing 3 mean on a Hunter thermostat?

A flashing 3 means the third setting is currently operating the heater or AC.