How do you program a Mazda 5 key fob?

Step-by-Step procedure

  1. Remove the key from Ignition Switch, close all doors in your car, open the driver door only and leave it open.
  2. Close and open the drivers door three times.
  3. Push the Unlock Button twice on the first Remote to be programmed. The door locks should cycle to indicate successful programming.

Can I program a new key fob myself?

Can you program a new key fob yourself? If it is only the key fob itself to unlock the car, you can most often program it yourself.

How do I program my Mazda key with only one key?

Programming a Single Key

  1. Insert the key into the ignition, and turn it to the on position.
  2. Leave the key in this position for 10 minutes and 30 seconds, and then turn it off.
  3. Turn the key back on, and wait for additional 10 minutes and 30 seconds before turning it off again.
  4. Repeat the process for a third time.

How do I find my Mazda key code?

In order to retrieve your Key Code and Vehicle Pin you need to be registered with the National Automotive Service Task Force or Vehicle Security Professional Registry. If you’ve already registered with NASTF and would like to proceed, please click on the appropriate option below to begin.

How do you program a key fob for a 2010 Mazda 5?

  1. Enter Programming Mode – Step 1. INSERT first programmed transponder key into the Ignition and TURN to the ON position.
  2. Enter Programming Mode – Step 2. WITHIN 5 seconds, INSERT second programmed transponder key into the Ignition and TURN to the ON position.
  3. Program Remote.
  4. Exit Programming Mode.
  5. Test Remotes.
  6. Share.

Why is my Mazda key fob not working?

If your key fob isn’t working until you’re right up to the vehicle, then it might have too low of a charge. The first thing to try is a spare electronic key fob, if you have it, otherwise you can also try putting in a new battery. If this doesn’t work, then the transmitter inside the car could have an issue with it.

Can AutoZone reprogram key fob?

If you have a newer vehicle that uses a transponder key (identified by a black plastic key-head), AutoZone can hook you up with a key and program it for your car at a fraction of the cost of a dealership.

How do you program a Mazda transponder key without the original?

Steps to Program Transponder Key Without an Original

  1. Turn on Ignition. Sit in the driver’s seat and put the key in the ignition.
  2. Wait. The security light must remain on for 15 minutes.
  3. Switch Off and On. Once you’ve waited 15 minutes, the security light should go off.
  4. Repeat Steps.