How do you join a stagger decking join?

A common method for staggering a deck is to start the first row with a full plank, then cut one-third of the next row’s first board off the end. The row after that has an additional one-third cut off and then repeat when you get back to a full board.

How do you stagger composite deck boards?

“Stagger your boards so their ends are in different spots.” Slide the next board in so it’s parallel to the first. The sliding motion is important, as you want the spacer to fit in the groove of this board, too. Basically, you’ll have two boards with the spacer between them.

Are you supposed to stagger deck boards?

Composite decking should not be staggered on a deck. Staggered decking requires butt joints, but composite decking expands and contracts with temperature changes making butt joints unsightly. It is better to design a composite deck with intentional design elements to avoid staggering boards for a wider composite deck.

Can you join decking boards?

Absolutely no problem with that, except then your screws/nails do not line up with the rest of the boards on that joist. That is the main benefit of what I was trying to show; just try to spot the join in the first pic below. It is always nice to see another technique- method in deck construction.

Should you leave gaps between decking boards?

Determining Deck Board Spacing When using wood decking, you want a gap of at least 1/8 of an inch after your decking has dried out. If you’re using decking that’s already been dried out, you can leave a 1/8-inch gap when you install. Many decks will use “green” wood, or wood that hasn’t been dried down or kiln dried.

Can you splice deck boards?

Whether you have one bad deck board to replace or many, the process is the same. We’ll show you how on an old, weathered deck, because you can save hundreds of dollars in lumber by splicing in boards instead of replacing the entire decking.

Is it OK to stagger composite decking?

What is the correct way to lay decking boards?

“The proper way to install a decking board is ridge side down.” The ridges are designed to allow for airflow, to stop moisture sitting in the ridge, and allow for a stronger structure. These lead to a less slippery deck as the moisture can drain better, and it can air dry.