How do you enter config mode on a Cisco AP?

at the prompt: AP(config-if)#? To exit interface configuration mode and to return to global configuration mode, enter the exit command. To exit interface configuration mode and to return to privileged EXEC mode, enter the end command, or press Ctrl-Z.

How do I change the IP address of my Cisco access point?

Using IPSU to Set the Access Point’s IP Address and SSID If you want to change the default IP address (10.0. 0.1) of the access point, you can use IPSU. You can also set the access point’s SSID at the same time. Note IPSU can change the access point’s IP address and SSID only from their default settings.

What is config t command?

In privileged mode, you can show anything but not make changes. Next, type config terminal (or config t) to go to global configuration mode (where the prompt looks like router(config)# ). From here, you can change global parameters.

What is configure terminal command in Cisco?

Cisco Commands Cheat Sheet

Basic Configuration Commands
Command Purpose
configure terminal Logs you into configuration mode
interface fastethernet/number Enters interface configuration mode for the specified fast ethernet interface
reload An exec mode command that reboots a Cisco switch or router

How do I assign an IP address to a device?

Assigning Static IP address to most devices is easy, just go to its network settings, look for DHCP option and turn it OFF. Once you do that, you’ll see a text area to enter Static IP address. Enter the new IP address there, save changes and that’s it.

How do I find the IP address of my Cisco access point?

To find the Access Point’s IP address

  1. Open utility window, make sure Get IP addr is selected in the Function box.
  2. Type the Access Point’s MAC address in the Device MAC ID field.
  3. Click Get IP Address.
  4. Write down the Access Point’s IP address that appears in the IP Address field.