How do you change the delay on a Simon XT?

Simon XTi – Setting Entry Exit Delay Times

  1. Press bottom right GEAR icon then press DOWN ARROW several times.
  2. Press ENTER by System Programming then enter Installer Code 4321.
  3. Press TIMERS then press ENTRY DELAY or EXIT DELAY.
  4. Enter Delay time 30 to 240 seconds then press SAVE then CLOSE several times to exit.

What does no entry delay mean on security system?

No Entry Delay– Once armed, the system will bypass the entry delay that normally occurs when an entry/exit zone is violated. Bypass Open Zones– The system will bypass open zones while arming the system. This feature can be used to attempt to force the system to arm regardless of zones that may be open.

How do you reset a GE Simon XT?

You can reset an Interlogix Simon XT to factory defaults by first powering down the panel completely. Then hold down the four top buttons on the panel while the system is being powered back on. If successful, the Simon XT will reboot with its factory default settings fully restored.

How do you check the status of a Simon XT?

Simon XT – Sensor Test

  1. Press until Sensor Tests then press.
  2. Enter Master Code then press.
  3. Open door or window, walk by motion detector, or press key fob button.
  4. Simon XT beeps 1 to 8 times indicating signal strength.
  5. Sensor Tests exits when all sensors are tested or by pressing STATUS.

How do you bypass the sensor on a Simon XT?

Simon XT – Bypass Sensors

  1. Press Doors+Windows then Motions to Arm.
  2. Press Bypass then enter Master Code then press or to scroll sensors.
  3. Press OK or BYPASS to bypass and Arm.

How do I set my ADT to stay no delay?

STAY NO DELAY Mode:

  1. Most DSC Panels: press STAY “one touch quick button” until it beeps then press *9 for the NO Delay feature.
  2. On some security keypads, like Honeywell, this is called Instant Mode arming.

What is the difference between armed stay and Armed away?

Armed Stay is the arming mode you should use when remaining in your home, such as at night when sleeping. Armed Away is the arming mode you should use when leaving the home.

How do I program my Simon XT?

Simon XT – Motion Detector Programming

  1. Press or until SYSTEM PROGRAMMING then press.
  2. Press or until SENSORS then press.
  3. Press again to place panel into learn mode.
  4. Simon XT beeps and “Grp” flashes, press.
  5. Sensor name flashes, press or to scroll names then press to select.
  6. When finished press.