How do you adjust the temperature on a Traulsen refrigerator?

How to Set theTemperature on a Traulsen Refrigerator

  1. Enter “O” “A” “1” on the control panel, followed by “Set.”
  2. Wait for “CUS” to appear on the display.
  3. Wait for three zeros to appear with the left zero flashing.
  4. Wait for three zeros to appear with the center zero flashing.
  5. Press the down arrow key until “A” appears.

What is a defrost lockout?

The lockout prevents the unit from going into a defrost cycle during peak kitchen use. Note: The 24-hour clock must be set for this feature to operate correctly.

How do you read a traulsen serial number?

Serial number date code traulsen The format of the traulsen s/n starting T… and ending letter, number, number gives date of manufacture – letters a-l month jan-dec, numbers are year. Eg: C08 is March 2008. Hope that helps.

What is soft lockout?

Soft lockouts refer to the situation where your furnace will let you attempt to start it again. If it fails to ignite, the furnace will go into a hard lockout. In this case, a manual reset will be required, which an HVAC professional should do. Furnaces can go into lockout because of four reasons: Flame sensors.

What causes a hard lockout on a heat pump?

If the temperature is too high or the pressure too low, the limit switch will close, instructing the furnace to shut down and enter lockout mode. A dirty filter may also cause the limit switch to trip by reducing the air flow.

Where are Traulsen refrigerators manufactured?

Fort Worth, Texas
Every Traulsen product is engineered, fabricated, assembled and tested at our facility in Fort Worth, Texas. When you are purchasing equipment that is meant to last a long time, you deserve to know not only what goes into it, but where it comes from. Traulsen is proud to offer products designed and built in Texas.

How do I reset my furnace after lockout?

Regardless of the culprit, you will have to perform a reset procedure to get your furnace out of lockout. Most modern gas furnaces can be reset by turning off the power, waiting around 20 seconds, then switching the power back on. Other furnace models may exit lockout after 1-2 hours and attempt to power on again.

At what temperature should I lock out my heat pump?

I would set the system to lock out at 35 degrees. Below that the furnace is likely more efficient than the heat pump. If the heat pump cant keep up at that temperature, the furnace will come on any way. Remember, Air Conditioning begins with AIR.

How can the safety lockout be reset?

Though lockout mode errors and resets do vary from manufacturer to manufacturer, most use a simple reset procedure that involves turning power off to the furnace for thirty seconds or longer and turning it back. The interrupted power supply clears the lockout and will allow the unit to attempt normal operation again.