How do I setup my HP ProCurve switch?

How to: Configure a HP ProCurve switch

  1. Step 1: Connect your serial connection.
  2. Step 2: Conenct PuTTY.
  3. Step 3: Get the IP address.
  4. Step 4: Set time server.
  5. Step 5: Set SNMP community info.
  6. Step 6: Launch the web GUI.
  7. Step 7: Configure basic info.
  8. Step 8: Create VLANs.

How do I format my HP switch?

Solution:

  1. Using pointed objects, simultaneously press both the Reset and Clear buttons on the front of the switch. The power and fault lights come on.
  2. Continue to press the Clear button while releasing the Reset button.
  3. When the Self Test LED begins to blink, release the Clear button.

How do you reset a ProCurve 1800 24g?

How do I reset factory defaults on the ProCurve 1800 Series Switches?

  1. Remove the power cord from the back of the switch.
  2. Connect port 1 to port 2 on the front panel, using a standard network cable.
  3. Reconnect the power cord to the rear of the switch.
  4. Wait at least 40 seconds before disconnecting port 1 from port 2.

How do I configure my HP switch interface?

To configure an Ethernet interface follow the steps given below:

  1. Enter system view and use the command.
  2. Enter Ethernet interface view and use the command.
  3. Set the interface description and use the command.
  4. Set the duplex mode of the interface and use the command.
  5. Set the port speed ans use the command.

What is the manual part number for the ProCurve series 2810 switches?

Printed in Taiwan June 2006 Manual Part Number *5991-3844* 5991-3844 Title Quick Install Guide for the ProCurve Series 2810 Switches Author ProCurve Networking by HP

How do I set up my ProCurve switch?

ProCurve# setup ■In the Main Menu of the Menu interface, select 8. Run Setup For more on using the Switch Setup screen, see the Installation and Getting Started Guideyou received with the switch. To Set Up and Install the Switch in Your Network Important! Use theQuick Installation Guideshipped with your switch for the following:

Does the series 2810 switch have a power switch?

NoteThe Series 2810 Switch devices do not have a power switch. They are powered on when the power cord is connected to the switch and to a power source. For safety, the power outlet should be located near the switch installation. The switch automatically adjusts to any voltage between 100-240 volts and either 50 or 60 Hz.

Where is the serial port on a Cisco 2810 switch?

NoteThe serial port on the 2810 switch is an RJ45 port located in the lower left corner on the front panel of the switch. Also, if you are using the menu interf ace, you can access the CLI by selecting the Command Line (CLI)option in the Main Menu. Using the CLI