How do I setup my Dlink DIR 650 router?

Just open a web browser to access the Setup Wizard and follow the easy step-by-step instructions to get started. Create a secure network in seconds using Wi-Fi Protected Setup, which instantly creates a secure connection to a new device without the need to enter settings or create passwords.

How do I reset my Dlink DIR 655 router?

Step 1: With the unit on, place a paper clip into the hole on the back on the unit labeled Reset. Step 2: Hold paper clip down for 10 seconds and release. Note: Do not repower unit during this procedure. Step 3: The unit will reboot on its own.

Is Dir 655 a dual band?

The DIR-655 doesn’t have dual-band support. Its SharePort USB port can work with only one computer at a time.

How do I connect my Dlink WiFi extender to my router without WPS?

If your router doesn’t support WPS, go to ‘Method 2 – Without WPS button’ opposite. 1 Plug the extender into a power socket near your broadband wireless router (e.g. in the same room). Check the extender On/Off button on the top is switched on. Wait 20 seconds for the extender to boot up.

Why is my DLink router not connecting to the Internet?

If Disconnected- please try the steps below: – Power Off your Internet Modem (Not the D-Link Router) for 20 seconds and then power it back on. Wait up to 2 minutes and check the Network Status again. If the status changes to Connected, your internet should be working.

How do I put a password on my Dlink router?

How do I change my D-Link Router’s password?

  1. Step 1: Open your Internet browser and enter.
  2. Step 2: Enter the password for your Admin account in the field provided.
  3. Step 3: Locate the Wireless Settings from the drop down menus.
  4. Step 4: In the Password field, specify the new wireless password for the desired wireless band.

How do I find my D-Link PPPoE username and password?

Now we will be in the D-Link management interface page. Here you will want to click on the Manual Configure button towards the bottom of the screen. Next we will change the drop down box next to My Internet Connection is to PPPoE (Username / Password). Now a username and password field will appear below that.