How do I setup a router as an access point?

Simply connect the access point to one of the ports of your existing wired/wireless router then configure the access point’s wireless settings.

  1. Open the access point’s web-based setup page by entering the default IP Address “192.168.
  2. On the web-based setup page, click on Wireless.
  3. Enter the Network Name (SSID).

How do I join AP to WLC?

Steps

  1. AP needs ip address in the said order. (1.
  2. AP needs to discover WLC via either of the two mechanisms in the said order. [ 1.lyr2 2.lyr3 (makes list of discovered WLCs via 5 mandatory steps) ] <– Hunting for the WLC.
  3. AP needs to select one of the discovered WLCs.
  4. AP needs to join the selected WLC.

How do I reset my mobility Express?

How to: Restart/Reboot Cisco Access points/AP/Controller via Mobility Express

  1. Login to Mobility Express web gui/web UI.
  2. Click on Advanced.
  3. Click on Controller Tools. Cisco Aironet, Mobility Express – Advanced, Restart Controller.
  4. Click on Restart Controller to reboot the Access Point/Controller.

How do I reset my Cisco AP to factory settings?

Reset Cisco Wireless AP to factory defaults

  1. Connect the console cable.
  2. Unplug the power or network cable if connected to a POE switch.
  3. Press and hold the Mode button.
  4. Plug the power back into the AP.
  5. Wait until the output on the console says button is pressed.

How do I mount the Cisco Aironet 2600 access point?

8 Mounting the Access Point Cisco Aironet 2600 series access points can be mounted in several configurations, including on a suspended ceiling, on a hard ceiling or wall, on an electrical or network box, and above a suspended ceiling.

What do the 2602i model access points look like?

The 2602I model access points have integrated antennas and do not have external connectors on the top of the unit; however, they do have the LED indicator on top of the unit, as shown in Figure 2. 6 Figure 1 Access Point Ports and Connections (top) Figure 2 Access Point LED Indicator (top)

Can I use a 2600 series access point with a controller?

Keep these guidelines in mind when you use 2600 series lightweight access points: †The access point can only communicate with Cisco wireless LAN controllers, such as 2500 series, 5500 series, and WiSM controllers. †The access point does not support Wireless Domain Services (WDS) and cannot communicate with WDS devices.

When is the AP configuration done for the WLC?

The ap configuration will be done once the ap joins the WLC and is in the REG state -Scott *** Please rate helpful posts *** View solution in original post 0 Helpful Reply Scott Fella Hall of Fame Guru In response to waleed3sa Mark as New Bookmark Subscribe Mute Subscribe to RSS Feed Permalink Print Email to a Friend