How do I reset my line 6 pod?

Lowdown: power on while holding down the ‘A’ button for 5-8 seconds. Pocket POD: Hold the save button and 4-way arrow key up while plugging a cable into the instrument input to power the unit on. The unit will prompt for a factory reset, press save to initiate the factory reset.

How do I factory reset my pod?

Hold down the UP and DOWN buttons as you turn on the power. This will reset the processor and restore all factory presets.

How do I factory reset my line 6 Helix LT?

Restore stock presets + setlists + IR’s and Globals: Hold footswitches 9 + 10. Reset Globals: Hold footswitches 5 + 6. Erase and restore/reset all factory and user presets: Hold footswitches 10 + 11.

How do I factory reset my apex?

To put the Apex into WiFi access mode press and hold the reset button until the status LED changes to BLUE (about 6 seconds), then release the reset button. To initialize the Apex to factory settings press and hold the button until the status LED turns RED (about 30 seconds), then release the reset button.

How do I reset my Helix terminal?

Press the A and D buttons simultaneously for 5 seconds, until the indicator light goes from red to green. Press 9, 8, and 1 on the keypad at the bottom of the remote. The indicator light will flash 3 times to confirm the remote has been reset.

How do you reset line 6 HX Stomp?

Hold these button combinations while powering up the HX Stomp XL:

  1. FS ^, C & D: clears all presets/IRs.
  2. FS ^+C: resets presets and IRs.
  3. FS C+D: factory restore (globals, presets, IRs)
  4. Page >: Update mode.
  5. Upper & Lower Knobs: Rebuild presets.

How do you unpair an apex pod?

How do I unpair my Tracker from my account?

  1. Ensure Bluetooth is enabled on your phone.
  2. Ensure your tracker is powered on.
  3. Press the ‘More’ button.
  4. Press “Configure Apex”
  5. Press “Unpair Tracker” and follow the steps.