How do I reset my Duet washer?

Unplug the washer for 30 seconds to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.

How do I reset my Whirlpool Duet direct drive?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.

How do I fix F28 error on Kenmore washer?

How to Unlock a Kenmore Washer HE2 Code F28

  1. Press the “Stop” button twice.
  2. Press the “Rinse/Drain & Spin” button on the control panel to drain the washer and spin any remaining water out of the tub and clothes.
  3. Pull the washer door open and close it to reset the appliance.

How do I reset my Whirlpool Duet front load washer?

Method 1: Unplug it The first way you can reset whirlpool washer top load is by unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again. This performs a hard reset on the machine and it will start over after you reconnect it again.

How do you reset a front loader washing machine?

Unplug the washer and let it sit for a minimum of two minutes, preferably five or ten. This will give residual water in the pipes a chance to drain out. Re-plug the washer and push the start button. It will run through a short cycle and then shut off again.

How do I reset my Whirlpool direct drive front load washer?

How do you unlock a direct drive on a Whirlpool washer?

Push the Start/Stop button to unlock the washer door during the spin cycle. Pause the machine by quickly pressing the Start/Stop button once. After a few seconds, the washer will halt and you’ll hear the door unlocking. Add any extra garments into the washing drum at this time, if necessary.

What does F28 code mean?

Vaillant officially defines the F28 error code as an ignition fault. There are many potential causes to this problem including an insufficient supply of gas, a faulty electrode or ignition lead. Therefore, the causes of the F28 fault can be broadly categorised into either an ignition fault or a gas valve fault.