How do I reset my Drayton receiver?
How do I reset my Drayton receiver?
Pull down the battery drawer in the Digistat unit and the screen will go blank. 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds.
How do I connect my British Gas wireless thermostat?
Push ‘overide’ button on the receiver once, the green LED should come on. Push button 1 followed by 2 and hold them both depressed together Red LED will flash for 2 secs then go out (learn mode) Release both buttons Red and Green LED should now both be on.
Why is my thermostat not communicating with boiler?
When the low batteries eventually die, you’ll see a black display screen and the thermostat will stop working, meaning your heating system will go down as there is no temperature command being sent to your boiler. In order for thermostats and boilers to work, they need to be able to communicate well with each other.
How do I reset my British Gas wireless receiver?
How do I reset my Drayton Digistat?
Reset If at any time during the programming you get confused and would like to start the procedure from the beginning press the SELECT and – buttons at the same time and hold for two seconds. This resets the Digistat to the factory preset times and temperatures shown in the table (overleaf).
Why does my thermostat say no signal?
Screen displays “No Signal” Thermostat has lost radio contact with the wireless network (usually because of a power outage). To restore power: Check circuit breaker and reset if necessary. Make sure power switch at heating & cooling system is on.
Why is my British Gas wireless receiver flashing red?
The red light labelled “receive/alarm” has different functions. If it flashes every few seconds its indicating a weak signal from the room thermostat. That usually means the batteries in the room thermostat need changing. If you look at the room thermostat display you may see a “low battery” indication.
