How do I reset my D Link DAP-1360 router?

How to reset a router to factory defaults

  1. Step 1: Find the reset button. There should be a tiny reset button.
  2. Step 2: Push the reset button. While the router is on, push and hold the reset button.
  3. Step 3: Hold the reset button.
  4. Step 4: Reboot the router.
  5. Step 5: Log in to the router.

How do I log into my Dlink DAP-1360?

Type 192.168. 0.50 (the default IP to access the admin interface) in the address bar of your internet browser to access the router’s web-based user interface. You should see 2 text fields where you can enter a username and a password. The default username for your D-Link DAP-1360 is admin.

Is D Link DAP-1360 a router?

The DAP-1360 offers seven modes of operation, namely Access Point, Wireless Client, Bridge, Bridge with AP, Repeater, WISP Client Router, and WISP Repeater (Range Extender) Mode….Specs.

Wireless standard Wireless N
Wireless modes Access Point (AP) Wireless client Wireless extender
Download the datasheet.

How do I connect my D-Link WiFi extender to my router without WPS?

If your router doesn’t support WPS, go to ‘Method 2 – Without WPS button’ opposite. 1 Plug the extender into a power socket near your broadband wireless router (e.g. in the same room). Check the extender On/Off button on the top is switched on. Wait 20 seconds for the extender to boot up.

How do I reset my D-Link WiFi extender?

Using a paperclip, press and hold the reset button for 10 seconds (or until the LED on the front turns red), and then let go. The extender will then reboot and be at factory default settings.

How do I access my Dlink access point settings?

How to change a D-Link router to AP mode

  1. Connect a computer to the D-link router and launch a web browser.
  2. Visit the following router configuration page: http://192.168.0.1.
  3. You are prompted to enter a username and password.
  4. Click Setup > Local Network.
  5. Set the DHCP Mode to Off.
  6. Click Apply Changes.

How do I enable repeater mode on my Dlink router?

Click Login. Step 3: Click the Wireless tab on the top and then click Wireless Repeater from the menu on the left-hand side. Or click on Site Survey to display the list of available APs for selection. Select the desired AP and Click Next to continue.

What is the default IP of DAP 1360?

IP Address 192.168.0.50 Load Admin
Username admin
Password
SSID
Users Manual Manual 2

Why is my D-Link Wi-Fi extender not working?

If the D-link extender stopped instantly, then you need to try to restart your d-link extender and resolve your issue in one step. To Restart Your D-link extender just plug out your d-link extender from the power outlet.

Why won’t my D-Link connect?

If Disconnected- please try the steps below: – Power Off your Internet Modem (Not the D-Link Router) for 20 seconds and then power it back on. Wait up to 2 minutes and check the Network Status again. If the status changes to Connected, your internet should be working.