How do I reset my Cisco 1800 series?

How do I reset my Cisco 1800 series?

How to Factory Reset 1800 series Cisco router

1. Connect you PC to the router via console cable and connect using Putty.
2. Boot the router while holding ctrl and break get into rommon1>
3. Type the following command.
4. Type Reset to start the factory reset.
5. To enter config mode, issue the config terminal command.

How do I get into Cisco ROMmon mode?

To manually boot into the ROMmon mode, you will need to reboot the device and break the boot sequence. Pressing the Ctrl+Break key combination during boot usually does this.

How do I get out of Cisco ROMmon mode?

These are three ways the router can enter ROM Monitor (ROMmon) mode (rommon#>):

1. Reload, initialize, or power cycle the router with the configuration register boot field set to 0.
2. Reload, initialize, or power cycle the router without having a Cisco IOS Software image to boot from.

How do I fix ROMmon mode?

If your router gets stuck in ROMmon mode during the boot process, examine the value of the configuration register by entering the confreg command. Change the value of the configuration register as shown below to stop the router to go into the ROMmon mode after reloading.

How do I Reset my Rommon router?

Press break on the terminal keyboard within 1 minute of power up in order to the router into ROMmon. Enter in confreg 0x2142 at the rommon 1> prompot in order to boot the from Flash. Type reset at the rommon 2> prompt. Type no after each setup question or press Ctrl+C to bypass all questions.

How do I Reset my cisco 1811 to factory settings?

Find the Reset button on the router. Press and hold the Reset button while you power on the router. Release the Reset button after 10 seconds. Wait 5 to 10 minutes for the router to finish booting.

What is Cisco Rommon mode?

ROMMON mode is a router mode, not a mode within the Cisco IOS XE software. The ROMMON software and the Cisco IOS XE software are two separate programs that run on the same router. At any given time, the router is running one of these programs, but it never runs both at the same time.

How do I boot an image from Rommon?

Copy a bootstrap program from ROM into the RAM, run the bootstrap program. The bootstrap program looks for the first IOS image on the flash memory, extracts it into RAM and boots the IOS image. When there is no IOS image, it will boot into ROMMON.

How do I factory Reset my Cisco router?

Reset Router to Default Configuration

1. With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
2. Find the Reset button on the router.
3. Press and hold the Reset button while you power on the router.
4. Release the Reset button after 10 seconds.

How do I Reset my cisco router to factory default?