How do I program my AT uverse remote to my TV?

Here’s all you need to do:

  1. With your TV on, use your U-verse TV remote and press Menu.
  2. Select Help > Information > Remote Control Setup.
  3. Next, select your remote control from the TV onscreen list. Refer to your specific remote for TV/device setup options.
  4. Select Top Ten Brand Setup, Automatic Code, or Manual Setup.

How do I reset my AT S10 remote?

S10, Silver, and Point Anywhere remote controls Press and hold the AT and the OK key simultaneously. Release both keys and all four mode keys will flash twice to indicate you are in programming mode. Enter programming code 900 by pressing the number keys on the remote control.

How do I sync my AT remote to my cable box?

Point your remote at the device, press the “Fast Forward” and “Rewind” buttons at the same time, and hold them for three seconds. 6. Wait for a confirmation message that your remote is paired and ready to use.

How do I program my uverse s20 remote?

Point the remote directly at the device you are trying to control/program. Press the Menu and OK keys simultaneously for three seconds until the Power key flashes red twice to confirm that you are in Program mode. Press the On Demand key to program your TV or the Interactive key to program your audio device.

Why is my AT remote not working?

Restart your receiver – Hold down the POWER button for 10 seconds then press it again to restart. This process will take 5-8 minutes and will impact any DVR recordings in progress. Order a replacement remote – visit the online Accessory store to order a replacement U-verse TV remote control.

Why is my Samsung TV not responding to the remote?

Remove the batteries and then press Power for 8 seconds to reset the remote. Then reinsert the batteries and try to use the remote again. Check out the user manual if you need help accessing the battery compartment. 2 Check to see if the remote is sending an infrared (IR) signal.

How do I connect my new remote to my Samsung TV?

On most Samsung TVs, the remote control sensor is located on the lower right hand side of the TV. If not, it is directly in the bottom center. Next, press and hold the Return and Play/Pause buttons simultaneously for at least 3 seconds. Your TV will begin syncing with the Smart Remote.