How do I pair my phone with Alpine CDE W235BT?

For Alpine CD Headunits CDE-133BT, CDE-135BT, CDE-136BT, CDE-HD137BT, CDE-HD138BT and CDE-W235BT

  1. Press and hold the phone/setup button for three seconds to enter “Setup”
  2. Using your volume control, select “Paired Dev” and press “Enter”
  3. Using your volume control scroll through the list of paired devices.

How do I pair my Alpine CD receiver?

Search. A: While in your car, go into your iPhone Settings > Bluetooth, and turn on Bluetooth. On the Alpine CD deck, switch through the modes until it says BT Audio. On your iPhone, under Bluetooth again, hit Connect/Pair with device Alpine Receiver.

How do I set the clock on my Alpine CDE W235BT?

Press and hold audio/setup button for at least 2 seconds to activate the SETUP selection mode. Turn the Rotary encoder to select GENERAL, and then press “ENTER”. Turn the Rotary encoder to select the CLOCK ADJ mode,and then press “ENTER”. The time indication will blink.

How do I remove Alpine double din?

Use a flat head screwdriver to carefully pry up the plastic bezel surrounding your stereo. There are several plastic tabs holding the bezel in place, so start on one side and work around until the bezel loosens. Once it is loose, slide it off of your stereo.

How do I reset my Alpine car stereo?

To reset the stereo, hold that key and the Number 6 button at the same time.

How do I connect my Bluetooth to my Alpine head unit?

How do I pair my phone with my Alpine head unit?

  1. Using your BLUETOOTH compatible device, search for available Bluetooth devices.
  2. Turn the Rotary encoder to change the head unit display from “PAIR NO” to “PAIR YES”, and then press ENTER.
  3. If the pairing was successful, “CONNECTED” is displayed for a few seconds.

How do I remove my Alpine head unit without a key?

All you have to do is insert the pieces of wires into the keyholes simultaneously and when you can feel the clips, push the wires away from each other. Another effective method of removing Alpine head unit without keys is to use a coat hanger.

How do I remove an Alpine CD receiver?

Removing an Alpine CD player is not a difficult process. Insert the small flat head screwdriver behind the lower right corner of the CD player’s plastic trim ring. Keeping the head of the screwdriver behind the trim ring’s edge, slide the screwdriver around the perimeter of the trim ring until it pops off completely.